开云体育

Just got mine 15 mins ago, and it's my umteenth birthday today too - very apt :) Now to find the latest firmware to upload to it.

Thanks Erik, just loaded the latest firmware 1.0-44 and all is good. I tried to run it on the tiny sa windows 10 program, but very intermittent no worries all ok...

Yes, just like the nanoVNA, same two pins to connect switch off the tinySA Open the case Connect BOOT0 with VDD switch on the tinysa wait 5 seconds remove the connection update firmware

Hi Erik My fault! I tried to upload the firmware, using the usual tool,but found the fw was not readable... So I simply made it readable - 'now there's the problem' It then did something and now my

Left it on until the battery indicator went red, less the 3v I then put it on charge. Will only charge to 3.4v and battery indicator 1/4 full. Has been on charge over 2 hours. Ray

What value is shown?

Does not display 4.2 so maybe charging IC

On Fri, Aug 7, 2020 at 08:13 AM, Erik Kaashoek wrote: A delta marker would have done the calculation for you. It is currently not possible to place a marker on a stored trace. Is it something that

Same here, huge kudos to Erik, Hugen and Maggie Ordered on Alibaba on July 23 Delivered in Boston: Aug 5 First test: after the initial setup steps, output of my Elecraft XG3 at -73 db into tinySA,

Herb A delta marker would have done the calculation for you. It is currently not possible to place a marker on a stored trace. Is it something that should be possible

A quick estimate of FM deviation using a spectrum analyzer that my former lab used was: 1). Capture the unkeyed carrier [Display->Store Trace], 2). Key the carrier and measure the deviation between

Sorry, I will check the additional battery check items and Maggie will send you a new tinySA as soon as possible. Please help check whether vbat displays 4.2V after removing the battery. If it

WHen you switch on the tinySA, does it work? If you unplug the USB does it switch of immediately or does it work for some time?

The red led is still on after 12 hours of charging. Indicator says 3.3v and is 1/4 full Ray

red led is on. Battery indicates 3.2v and 1/4 scale after 12 hours of charging.

The red led is just to the right of the USB connector as seen from the front/top Is the red light on, off or blinking when connected to a charger?

Hello Ray, the red LED is on when charging, and the red LED is off when it is full. Is the battery not working now?

Alibaba Can’t get into account. Tried to reset password, new password does not meet standards but standards are not listed. Guess I will toss it and call it a bad day.

Contact the seller. They will tell you what to do. If you did buy from one to the official stores of Hugen you will be surprised by his customer care!!!

Arrived a few days ago. Battery will not charge. Ray W8LYJ