开云体育

Brad, KN4ODM, Vidas, N8AUM I received the same CLONE - why do I know it's a clone? Look at the picture, it says "HICH" and not "HIGH" on the front panel. This is not a bad print, no, it's simply a

Yeah, I did both, just to see what happens, for interests sake. Things With IN connected to OUT, all's good, as expected. :)

I suppose I can.? Since the thing works, I have always dislike "upgrading for the sake of upgrading", unless there are some supremely marvelous added features/enhancements. 1.0_91_g0f9078f is my

If you own one of the original NanoVNA or the TinySA with the 2.8 inch screen there is one small problem, it either has no case or a plastic case. For the TinySA this becomes a problem when you live

Erik, all kind of different cables and ports was the very first thing I tried - without success ?

Sorry didn't care about the good test with cable . All look to be ok . [email protected]> a écrit :

Hello, the result looks like the self test has been done WITHOUT the cable between High and Low sockets. Joe , did you connect the cable during the test or you missed it ? Regards.

Try a USB 2.0 port Try a different USB cable -- ------------------------------------------ For more info on the tinySA go to https://tinysa.org/wiki/

Thanks Hugen for the info, I guess so. If I connect, I just see in 'USB-Controller' an 'Unknown Device' and in this device property: *This device does not work properly because the device firmware

Looks good Can you upgrade FW and run selftest? -- ------------------------------------------ For more info on the tinySA go to https://tinysa.org/wiki/

Greetings, Eric: Going through the thread, I would like to think my purchase via Amazon.ca is a genuine article. Would you please check? Also trying to figure out the firmware details. The

This is a clone, but the USB driver has nothing to do with whether it is a clone or not. The USB-CDC serial port can be correctly identified without installing a driver on a fully installed Windows 10

Erik, thanks for the reply! Oh yes, it says 'HICH' on the front and not 'HIGH' :-( Sorry, will check at Zeenko Store on Aliexpress - up until mid of this year, there is no customs & VAT charge...

Seller Toolbox-store is known to have sold at least one clone. Can you post a picture of the front and back of the tinySA? -- ------------------------------------------ For more info on the tinySA go

Hi all, received my tinySA today (Aliexpress Toolbox-Store). Since some buyers reported in this shop: 'no clone' I did risk it, because it was delivered within ~ 1 week from Czech Republic to Austria

Erik, please don't think too technically:?I have no idea about how TinySA is designed so I didn't know that its flash memory is so limited. Since other instruments do that, I just asked if it's

No, it is a good way to get back to a fixed starting point and reset any forgotten settings. If you want to restore a set up save it in one of the memories ther for that purpose. 73 Jeff

The minimum frequency resolution of the output is, depending on the frequency, 156Hz or 312Hz,?50Hz steps are not possible. -- ------------------------------------------ For more info on the tinySA

FM only, so yes should be fine

I didn't think you were criticizing the design, Ian, sorry if I came across that way.? I just figured 50 Hz would be close enough for normal testing.? Certainly for AM and FM CB signals, and for SSB