开云体育

Hopefully this is helpful.

Can you post somewhat bigger pictures of both test 10 and 11 with their message? Not the final selftest status screen -- ------------------------------------------ For more info on the tinySA go to

I just received my TinySA on friday. So after watching videos on how to use it, I ran the selftest and I have a couple of errors. Test 10 gives me a signal level critical error and test 11 give me an

I just installed the new firmware and when running the self test on test 10 I'm getting Signal level Critical? for the status. Then on test 12 I'm getting Attenuator Fail for the status. I just

Recently purchased a tinySA from aliexpress Zeenko Store - https://www.aliexpress.com/item/4001274404758.html The first self-tests were fine prior to updating the firmware, but I'm having failures on

Oh there's the hole! Thanks. That's very helpful. That wouldn't be a bad thing to add to the Wiki or starting videos for us old guys with bad eyesight.

I find that the TinySa is very useful as a signal generator and use it to test my SDR receivers and some RF projects I am building.? The new slider features and the external amp make it more easy to

Like this... Steve

Rob, There is an oblong hole in the back case near the jog switch.? Push the small thread loop through there (it may take a tiny tool to help), then thread the pick and lanyard through the small

Can somebody give me a clue about how you're supposed to attach the lanyard (with the little guitar pick on it)? I can't find anything to wrap it around, and the introductory videos never have a

Erik: Thanks for the new 1.76 firmware. I loaded it, and have discovered (as was suggested ) that my display is NG... that throws the error. So, I'll live without waterfall, the unit still performs

New FW release Version V1.1-76 Changes: - Corrected the bug that caused a hang after a failing display test. The display test is no longer the first test but test 11. Test 12 is now the attenuator

As the waterfall is also not working this "hang" is caused by an error in the self test when it detects it can not read correctly back from the display memory. I will correct this error in the next FW

Just had another look, the instant I hit the Self Test mode, I see (for a very small fraction of a second) a line of dots or dashes at the very top of the screen. They only exist for maybe 0.1 seconds

For the real TinySA with the white label, you can "laminate" the label with a piece of clear packing tape placed over it and carefully trimmed to fit the space with a sharp hobby knife. Recommended

Hello Erik, This test was with 1.1-75m freshy loaded.? ?My tinySA is HW V0.3? ? SN SA-20102809 The Level Cal works as expected, green progress "bar" etc, and completes. However, the Self Test

First run original TinySA. Firmware 75, both waterfall modes work OK, self test passes. 73 -Jim NU0C "Erik Kaashoek" <erik@...> wrote:

I expect the display test at the start of the self test fails. Let me try to simulate display failure and see how it behaves Do you see a single colored line appear at the top of the screen at the

Hello All: New tinySA user here, (I have a NanoVNA too).? My tinySA was from R&L, so should be real. I've had the unit for 3 weeks, worked well.? ?However, I have an odd issue when I load the

Back in another life I picked up some used SMA adapters from one of the regular hamfest vendors that seemed to be in good shape for just a few dollars. I looked up one of the Amphenol parts later and