开云体育

Erik: Serial number is SA-20100478 Version: v0.3 tinySA_v1.1-12-gccc0fbe Kernel 4.0.0 Compiler gcc7.2.1 20170904

I upgraded mine to 1.1-75 and it shows that firmware version. Also corrects the modulation in FM Narrow and FM wide carrier frequencies. I used IMSAI Guy's YouTube video and it worked

I upgraded the firmware this morning to 1.1.74. No problems. Then I saw the firmware upgrade to 1.1.75, so I thought I'd upgrade to the most current version. Loaded it. Everything seemed to work

Yes, Zeenko is the store of Hugen who manufactures all genuine tinySA -- ------------------------------------------ For more info on the tinySA go to https://tinysa.org/wiki/

Any of the Asian connector will work up to 350Mhz without problems and whatever small impedance bumps or loss they have from 400Mhz to 1ghz is less than the problems in resolution that the analyzer

Zeenko store currently have tinysa for ?37 plus ?5 carriage which is about the cheapest available anywhere. These are genuine? They also sell the saa2N for a pretty good price, too. Steve L

Thank you, requested a refound and will re-order from zeenko store. If only I had found this information before. Also pity I gave the seller 5 stars (like most others) for his fast shipping and cannot

As listed on the wiki page the seller tool-box store sells clones and you have indeed received a clone. -- ------------------------------------------ For more info on the tinySA go to

New FW release Version V1.1-75 Changes: - The error in the NFM and FWM carrier frequency has been corrected ------------------------------------------ For more info on the tinySA go to

I would use a male-female adaptor. Actually, I would probably use a male SMA to a female SMB adaptor. I have a lot of cables with SMB male plugs on them. The SMB's often seem to be overlooked, maybe

It's a clone. I had identical issues Alain

Hi Erik Thank you for the very quick reply. I was just doing so after also stumbling over the 'clones' thread. Got mine from Aliexpress (Seller: Tool-box Store) and so far it does not meet the

Please post a picture of the screen of the failing selftest? (7 and 8, not the final selftest screen) and a photo of the backside of the housing of the

Hi Gang Two days ago I received my tinySA. First thing I did after looking at the FM and 2m Ham-Band with the provided telescopic antenna, was a firmware upgrade. Unfortunately I didn't bother to

Will look into this. Guess something went wrong somewhere during an update -- ------------------------------------------ For more info on the tinySA go to https://tinysa.org/wiki/

I experienced the same thing, although I wasn't as sharp as Liam to track down the shift in the carrier, but just noticed that the tinySA didn't produce a carrier on the assigned frequency when either

Look at the attenuator level. Sometimes it stays at 30 with no signal present. -- ------------------------------------------ For more info on the tinySA go to https://tinysa.org/wiki/

My recently acquired (and on close inspection, genuine) TinySA with 1.1-74 firmware exhibits this behaviour. I discovered this by chance with my VX-7R, having found the carrier would disappear when I

I can occasionally connect to my Win10 PC although never when RBW is selected other than AUTO.? When it does connect the default settings noise floor is sometimes -58 dB and sometimes -80 dB.?

And when you need a SMA bullet, I recommend this style with a knurled center section: ebay # 202670005403