开云体育

Thanks you for you're reply, you confirm me the Tiny SA Ultra+ can't record the integrality of the realtime signal on his sdcard, and need external recorder ? What sort of model of rasberry pi is

This is new to me -- Designer of the tinySA For more info go to https://tinysa.org/wiki

Thanks for the quick reply and I'm glad it's an original. As I plan to buy some more I had to be sure that they are not copies. With the firmware it was stupidity on my part because I thought the

Eleshop for sure does NOT sell clones. Did the FW version number change? If not, you may have loaded the FW in the wrong direction (into your PC) or you have a problem with a USB 3 port Download the

Hello, I bought a TinySA from the secure seller Eleshop B.V. Nevertheless, I am not so sure that it is an original. The following points: Switching on only works by toggling the power switch and when

I have a whole set of those SMA 2 watt attenuators I use for a lot of things. They are in 1 dB increments between 1 and 10 dB, and 5 dB increments from there to 30 dB. I also have a Kay switchable

Yep my HP 8660 leaks a small amount but as long as proper cables are used it still seems to be accurate into a 50 ohm load. Within about 1dB.

Even my HP 8648C set to -136 dBm (the minimum internally available output) plus additional external attenuation leaks just a wee tiny bit! Still good for receiver MDS evaluations. I've never looked at

My approach would be to use one of those small SMA connector attenuators. They're fairly inexpensive and you can get them in levels from 3DB to 30 dB. That's what I use. I even use it for low-level

Minimum output level used to be -120 dBm but not all HW was able to reach this level so the limit was set to -115 dBm The limiting factor is leakage which can not be improved within current cost and

Is there any future plan to drop the minimum signal level output available below -115 dbm? This would be more useful for receiver sensitivity testing since most radios levels are around -117 dbm to

passed selft test, updated to newest fw

According to tinysa.org banggood removed tinysa trademark and now is selling only clones. But now, there is only one option for tinysa different models to buy and all of them has tinysa trademark and

Topic closed -- Designer of the tinySA For more info go to https://tinysa.org/wiki

I have and use an 8556 in the 852 mainframe. Didn't know it is BWO based. The lowest range which tops out at 3 GHz is pretty clean. The other ranges are the problem. And, yes, the "ID" button for use

I had an old HP 856/8556 BWO-based spectrum analyzer at my first job, in 1975.? It, like all of the old non-preselected analyzers, had plentiful images and mixing products. It had a Signal Identifier

I have a Polarad. Haven't used it in years. No room for it on the bench. It was my first SA "W0LEV via groups.io" <davearea51a@...> wrote: -- 73 -Jim NU0C

Very pleased to say I went to grab a copy of the 175 bin file which was the one thatI had trouble with, and there was the 199 bin file (wasn't there before)which loaded perfectly (using StmCube) with

I would welcome someone looking at the code and suggesting better ways to remove spurs and mirrors Shifting the IF is already done. -- Designer of the tinySA For more info go to