开云体育

Yes. David -- SatSignal Software - Quality software for you Web: https://www.satsignal.eu Email: davidtaylor@... BlueSky: @gm8arv.bsky.social, Twitter: @gm8arv

What frequencies are you targeting? The supplied antenna is good for 50 MHz and higher but is a lot less sensitive for 10 MHz and lower For low frequencies you better use a (home made) loop

Hi all, I’m new to this group, a physicist by background but also new to using a spectrum analyser. Before I go and actually buy the Aursinc V0.3.1 model, I wanted to ask about how I might go about

Try: Remove your SD card. Clear configuration Load defaults Level calibration "Gerd via groups.io" <gerd.vipre@...> wrote: -- 73 -Jim NU0C

I wonder if there is a possibility that the firmware is corrupted in some way. Perhaps re-installing the same version of firmware might produce a clue? Just my 2 cents! Sam Reaves ARS W3OHM Owner /

Basically I want to save continuous traces as fast as the TinySA ultra allows until the SD card is filled. With the autosave function the fastest it goes is 1 save every 30 seconds. When I manually

Hi. I did a "clear config" again and was able to set the time and date correctly. Last time I put a point between the dates and it broke the recording. The remaining errors are the

The fastest I have been able to get it to save is in 30 second intervals. Is faster possible? Would this require going into the internals settings? I can manually press save twice faster than 30

Critical is not failing, just a warning some test is on the edge If you still worry, follow the fault finding as described on this page. https://tinysa.org/wiki/pmwiki.php?n=TinySA4.FaultFinding to

Heb de TinySA ultra nog niet heel lang. Maar zie dat de zelftest faalt Zelftest 3 geeft signal level critical Ook met het vervangen van de kabel. Ik ga er eerst maar vanuit dat ik iets verkeerd

0.5 s is too quick, slower is possible -- Designer of the tinySA For more info go to https://tinysa.org/wiki

With nothing connected to the inputs and all default settings (after clear config)? the screen should look in a certain way. It should be like the first picture on this wiki page

Hi. Yes, I held the rotary knob on the right side and then started the device until the image appeared on the screen. I also did it while holding rotary knob on the left side. The situation does not

I managed to change my lna and input switch with a tiny iron and Chipquick removal alloy. Doubtless, I was just lucky but it can be done that way. Ross

Any input on how to save traces every 500 ms would be greatly appreciated. I've messed with all the settings to no avail. My best guess to to try to write a python program to tell the tinySA to save

I meant to say: Can you push the jog button to the side (NOT down) WHILE RESTARTING the device? So keep it pushed to the side until the full display appears. -- Designer of the tinySA For more info go

Hi. I did, but it doesn't change the situation. Yes, I took a picture of that too At the moment it seems that the fault is with the hardware, can the hypothesis be tested ? Sincerely, g.

Can you push the jog button to the side (NOT down) and restart the device? This should restore the normal scan display Did you connect CAL and RF with a short coax cable when doing the self

The device was purchased on 2023.12.10 from the official AliExpress store "Zeenko Store". I used the device a couple of times during the entire period and was satisfied with the device. In 2024, I

Hi. The situation you have is - honestly - a nightmare. With so many clients in a mesh network you mess up a lot of theoretically available bandwidth, so I am not really surprised about your