开云体育

I think the OP was thinking of a list of where clones were on sale, rather than details of the differences. Better to stick to the list of where to buy real ones

The criteria are set a bit too strict. Will update the FW in the near future to solve this minor problem -- Designer of the tinySA For more info go to https://tinysa.org/wiki

Hi Hasan, that is exactly the same selftest behaviour than with me! I have sent my Tinysa back to vendor, but I wonder it might be a systematic error. Perhaps the tolerances of test#8 are a bit

I can confirm that the latest firmware has fixed the spurs as reported on my ZS-407. after installing the latest firmware did a self test - all ok, but I notice that the reference level (top left) and

Thanks Bob, seems there will be no other choice than to get it exchanged. But i still wonder how "severe" it is if not passed !

Hasan, This sounds a lot like the problem that was reported and resolved just yesterday in this thread: /g/tinysa/message/19737 Bob W6CP

Hi, ""So you don't want reports of new clones of your hardware?? Am I getting that right?"" yup ....? there's pretty much nothing that can e done about the clone sites anyway ""If so, that's

bad guys on how to avoid detection. That's not rocket science. Please apply brain to issue and conform to the wishes of the developers who have done such a spectacular job. ++++++++++++++ --

Erik, Thanks for replying, wasn't expecting the designer to reply. So you don't want reports of new clones of your hardware?? Am I getting that right? If so, that's fine and will leave it at

Hi guys, I got the? TinySA Ultra+ ZS406 today from Eleshop. I updated the firmware to tinySA4_v1.4-198-g996a67b.bin (Picture 1). Before that, I had a Firmware from January 2025. I did the Self test

No. Please do not share any information on clones here. -- Designer of the tinySA For more info go to https://tinysa.org/wiki

I don't like FAKE hardware clones.? The original developers/artists/etc deserve that (as one myself). Is this the right place to report a new clone I found? Thanks.

Erik, Maybe you want to lower the tolerance for this self test item. Roger

Hugen, your comment is interesting for me, because the test fail #8 did not occur in every test run. Sometimes there are 4 or 5 good runs , but the next fails. Sometimes there a 3 or 4 bad runs that

Sorry, it really isn't a clone. This is due to a deviation in the IF filter, and although we have rechecked it several times during the production process, there are still some with smaller deviations

You did not buy from an authorized vendor so you might have received a clone.

This does not look good and can not be repaired by different FW or other user action -- Designer of the tinySA For more info go to https://tinysa.org/wiki

My TinySa Ultra+, just bought on Amazon from Pinsaitec, fails on selftest #8. I have implemented newest firmware, have done several calibration runs! No efford! What can I do, before returning the

If doing a restart while pushing the jog button to the side does not help its a HW fault -- Designer of the tinySA For more info go to https://tinysa.org/wiki

My TinySA ultra device is giving me a "SI4468 Configure Fail" error and is not coming up. Any advice on how to recover ? Thanks Sridhar