开云体育

One of the beta testers did a very good job at measuring the power linearity of an uncalibrated tinySA. Uncalibrated implies the absolute level may be a couple of dB off but the relative steps should

I write all info about in NanoVNA group in my firmware topic /g/nanovna-users/topic/nanovna_firmvare_compiled_by/73181877 For transfer data need eject SD card from slot and put in PC

Dislord, Will your SC Card support also include transferring stored traces to a PC?? What formats do you anticipate being a to store to the SC Card? - Herb

Will be a good solution for a future 4" version of the tinySA. In the 2.8" version there is not enough spare space at the edge of the PCB to place the SD cardslot

At this moment i implement SC Card support for NanoVNA H4, it very simple and good work. Use SPI interface some as display, need only SD_CS,?SPI_MOSI,?SPI_SCLK signals (SPI shared vs display and

And some practical?examples First DECT traffic just below 1.9GHz and second WiFi traffic around 2.45GHz. Red line is current signal, yellow line is power envellop

Having full control over the internals of the tinySA allowed some experiments at higher input frequencies using the mixer and BPF in a creative way. This of course required the elimination of the low

I will adapt the wiki to show the status of the availability of the HW

Thank you all that responded. I only wanted to be sure that the hardware was available or still not. Since I read a lot of messages in the group I was not sure if I had missed the launching

I have been in product development of high volume electronics (millions of products sold all over the world) and experienced a major post launch problem forcing a global recall. Launching too early is

The usual response to questions like that regarding products still in development is:? "It'll be ready when it's ready."

Shipping times are terrible and not all beta testers have received the HW yet. Once they have access we have to wait for their feedback.

Hola Ignacio, I have made the very same question today! And because of the same reasons... Anyway, I was redirected to: /g/tinysa/message/99 *73 de Luís, CT2FZI* *QRV @ 145.300

Is it possible to purchase a TinySA now?. I realize that it could be preliminary versions, but I think that all traffic in the group is too much for a very reduced group of beta

Been there, done that

???? Yep, it works now.? Thanks a bunch!? I like being able to get it on the "big screen."? These old eyes don't like that small stuff anymore.? I had to get headband-type magnifier with 5

Jim, Everything in tinysa-saver now only uses the tinysa name and (if I did not make any mistakes) you should be able to install it on your system next to having nanonvna-saver. You can also download

Hi Again I forgot to mention it was under Windows10 with Phyton 3.7 32bit //Kurt Fra: [email protected] <[email protected]> P? vegne af erik@... Sendt: 19. maj 2020 10:53 Til:

Hi Erik and others It works OK when remembering to set frequency start and stop before doing a sweep. On the TinySA the Attennuation and reference level must be set to manual in particular for

I cloned the tinySA repo, then attempted to install just as I had installed NanoVNA-Saver in the past, substituting "tinySA-saver" for "NanoVNA-Saver"? in the command.? It didn't install.? Looking