开云体育

Tested with different coax cable but same result..

Got problem with self test and calibration.. any ideas?

everything should be fine with you, the older younger version is determined by the bootloader, it seems to me that there are almost no changes in the difference between the versions, the difference is

Hi Richard, I just purchased the 406 from R&L arrived today. Mine has the same marking. My confusion is that the upper right under Zeenko is ZS-405, but S/N is SU-406-xxxx H/WV0.4.6. So did "they"

I checked the cables and adapters, they are ok. I couldn't check the RF signal via oscilloscope, probably because the signal is too low. But the 30 MHz signal is coming out, I tested it with an

I've been trying to align some HT's this week. After a lot of messing about I concluded that some of the commonly available "ham"style meters were somewhat variable in quality. So I decided to try

Sorry it is -35 dBm for ultra and -26 for smaller version.

Well on mine the 30MHz fundamental is consistently at -35dBm. No problems with tests and all attenuator steps as well as the LNA do function as expected. TinySA Ultra (SeeSii) Version:

I don't know what "support page" you were on before but this is the only place where the developer Erik supports the tinySA products.? Read this post about failing self-tests before asking more

Hello, I am not sure if I am confused :) but something is telling me that that I did read it somewhere, but I can't find it in the tinySA Ulta menus. Is there a, or was there an option to upload a

Through the dedicated tinySA support page I was forwarded to the tinySA groups. I'm not sure whether hardware issues can be reported along this way. I'm owning a tinyAS ultra, S/N SU-23080463. Since

New FW release Version V1.4197 For all tinySA Ultra and Ultra+ versions Changes: - Added CONFIG/EXPERT CONFIG/MORE/AUDIO AGC option. When disabled the PCB edge point PA4 will in listen mode have a

Just to rule out the obvious. Did you test with different coax cable? Is the call output set to 30 MHz visible on a scope? -- Designer of the tinySA For more info go to https://tinysa.org/wiki

After checking the low RF output in the generator function, I ran the self test. But the self test failed, stopping at item 3 and not continuing. I am attaching a photo of the test attempt. I have had

The following items have been updated in the Files area of the [email protected] group. * //tinysa-ultra-upgrade.sh ( /g/tinysa/files//tinysa-ultra-upgrade.sh ) *By:* Rob, W9LOT

Just uploaded a updated version of tinysa-ultra-upgrade.sh for files Please let me know me know if you encounter any issues and please attach the generated log file. Rob

Thank you! So I did python ./tinySA.py -e 'leveloffset low output -1' and also in the same vein python ./tinySA.py -e saveconfig Radek

I know it can be bought from the Zeenko store on AliExpress, but that means wasted time with customs formalities. It was preferable to be able to buy it from the European Union.

Use -e switch and enclose multi word command in quotes c:\work\VNA\tinySA\python>python tinysa.py -h Usage: tinysa.py: [options] Options: -h, --help ? ? ? ? ? ?show this help message and