开云体育

*Hello there,* *I am using the Tiny SA Ultra+ (ZS-406, firmware 1.4-196) and sending scan and scanraw commands to retrieve spectrum data, however I was wondering* *Is there any way to stop or abort

Do you have a question? -- Designer of the tinySA For more info go to https://tinysa.org/wiki

the level is different because the signal sources are not directly connected to the SA input, but were just near the connector. two signal sources, one with a lower freq. the other with a higher. SPAN

thank you, all the spurs are gone, just in case I cleaned the cable contacts with alcohol. ср, 12 февр. 2025 г., 12:22 Erik Kaashoek via groups.io <erik= [email protected]>:

Shorten C85 close to the audio connector Or use the pin header pin marked PA4 for for 0-3 V output -- Designer of the tinySA For more info go to https://tinysa.org/wiki

Just received my ZS-407 - a very nice little instrument :-) Seems like listening signal on 3,5mm jack is AC ??coupled? Is it possible to change it to DC coupling, so that a constant RF level gives

Is test 12 failing? If so, you can try to reseat the LCD cable -- Designer of the tinySA For more info go to https://tinysa.org/wiki

this problem immediately pops up after testing and remains so., reboot does not help, only reset. calibration goes fine. If you run the test, error 12 comes out, after that this peak remains. until

There are constant complaints here, it is not possible to rotate the picture from the mobile app, sorry. ср, 12 февр. 2025 г., 11:21 Святослав Маханьков via groups.io

There is a problem with this firmware. вт, 11 февр. 2025 г., 20:11 Erik Kaashoek via groups.io <erik= [email protected]>:

Tnx " It now goes up to 30,522 and interestingly, it works. I tested it at 24 and it sees a signal, I don't need it any further, but it probably works up to 30. Thanks for the

Hi and thanks for the advice. I've tried pausing the screen update on my TinySA Ultra, but that doesn't solve the problem I reported ...

Hi, with the various options visible in the vertical bar on the left of the image below and after recalling a previously saved preset, in my TinySA Ultra with firmware v1.4-196 there is a problem with

See Wiki. *EXPERT CONFIG* ( https://tinysa.org/wiki/pmwiki.php?n=TinySA4.SETTINGS ) activates the expert configuration menu * *HARMONIC* sets the harmonic to use in harmonic mode. Leave at 3 unless

Hi Question as regards ZS-407 why is it locked, is it? why can't we see how far it can go. we have a record that the first ultra see @20GHz.. " When you enter the frequency MENU, it says in the lower

I do this often with my nanovna-H4, and I haven't had a problem with the images directly appearing.? I just double-click on the image file name in the SD card panel, and it pops up the little window

This version has the function I was looking for and allows me to download the screenshots without having to connect the Sd card to the pc. The thing that I noticed is that sometimes the image display

DiSlord made the later revisions to nanovna-app, available on his github site: https://github.com/DiSlord/NanoVNA-App/tree/main/Win32/Release You probably just need to download the nanovna-app.exe

Thanks, I was trying it just yesterday, but I found the problem described here /g/tinysa/message/19418

QtTinySA (by Ian Jefferson), has the option to view and save the SD_card files on your computer. The new version of the program QtTinySA_win.zip is in