开云体育

To: Kurt Poulsen, Hi Kurt, a quick question: The very excellent Ultra Menu Tree document you published back on Aug 10, 2024, then current to ver 1.4.176, while mostly still up to date, lags behind

Hello. First of all, congratulations on a great job with the Tinysa ultra. I have the ZS405 version with firmware 1.4-192 and I would like to discuss a topic with you. The frequency accuracy in RF

Hello. First of all, congratulations on a great job with the Tinysa ultra. I have the ZS405 version with firmware 1.4-192 and I would like to discuss a topic with you. The frequency accuracy in RF

https://web.facebook.com/photo/?fbid=1180587507083729&set=g.2715786312037088 @ Mijo

Check out the post from this member:? /g/tinysa/message/14770? or search the archives for "10ghz" or "YIG". Herb

I'm working on resurrecting a Wiltron 6600 series sweeper (10 MHz - 18 GHz) with multiple problems (I think it was a combination of salvage parts). My old systron donner 762-2A spectrum analzyer (and

Hi DL2ECL, Set TinySA ULTRA harmonic for frq. you need to cover: CONFIG / MORE / EXPERT CONFIG / HARMONIC TinySA ULTRA frq. limits: 2. harmonic? 7.722 GHz 3. harmonic 12.072 GHz 4. harmonic 16.422

You don't need to do anything special Just select the frequency range of interest up to 12 GHz and it will scan the selected frequency range If you want to go to 18 GHz you have to change the harmonic

Hello. I am a radio amateur. Mostly I build and repair my own transverters.The tiny sa ultra is just fine for servicing my gear right up to 6 cm (5760 MHZ). I also need to work on my

Just as an aside my new model 407 recently arrived with V1.4-192 FW installed, now upgraded. Dino KL?S

I had a similar failure, also coincident with an upgrade, which left me with a white screen. Re-seating the cable restored the correct display. Best regards, Don Brant

That did it thank everyone for the suggestions especially Erick. Happy to be back in operation.

Thanks Erik for your effort and for the confirmation that its seams to be a real issue and not only based on my fault in operation. Markus

Try reseating the LCD cable, this has helped several people -- Designer of the tinySA For more info go to https://tinysa.org/wiki

Markus, Its best to copy/paste picture, not attach. Thanks for bringing this to my attention. I understand the issue and there may be a solution however the possible solution needs a lot of testing to

already tried that several times and several older versions with no luck.

Dear Eric, thanks for clarification concerning the usable FW for the ULTRA+ SA. In my exported spectrum from QtTinySA the LNA was enabeled when using FW -196-. I give it a try to attached again the

go back to an older version and see if that works.

No, Release V1.4-195 is the first public release FW which is suitable for the ZS-407 When you buy a ZS-407 it may contain an older FW version but that may a special version created before production

Tried suggestion but no change still no touch screen function and no menu displayed. I recall seeing the word touch displayed in the top righthand corner of the display when it flashed several times