开云体育

Yes You should never "RESET" a calibration as the current implementation of RESET is undefined and not updated for some time. I will remove that menu item

On a Z405 SW ver. 1.4-156 will saving the config (Menu: Storage|Save Config) also save all calibration data including the tables and individual level corrections? At the same token, when "resetting"

Perhaps you could terminate the input with 50 ohm and see what it scans. It should be a near flat line. And don't forget hdmi causes a lot of signals, as does other computer

Did you add a second trace with the "calc" option "max hold"? Cheers, David -- SatSignal Software - Quality software for you Web: https://www.satsignal.eu Email: davidtaylor@... BlueSky:

New FW release Version V1.4195 Changes: - Reduced spurs for ZS-407 -- Designer of the tinySA For more info go to https://tinysa.org/wiki

Mark, If you are worried about the update, you can always save the FW that brings yours and reload it again if in the new version it does not work. Toni

Dear Mark, if You bought your Ultra from suggested supplier, You got the original. There is no room for further questions! If You're still not sure , You not bougt from suggested supplyer. :) If

Keep the jog button pressed to the side during switch on If that solves the problem do a level calibration -- Designer of the tinySA For more info go to https://tinysa.org/wiki

Hello, I bought my Tiny SA Ultra some time ago from the suggested supplier so I am led to believe it is genuine. I have been lurking here for some time and have seen many messages from people who

I once turned on Listen mode on my *TinySA ultra* and shut it down - now it starts up in Listen mode by default every time; I have to manually uncheck the "Listen" checkbox at each startup. It saves

I hope to release a new FW that solves this problem later this week -- Designer of the tinySA For more info go to https://tinysa.org/wiki

OK. Even I've used that sort of TEM cell. Thanks for the cliarficatin. I did not read the original posting if I even received it... Thanks, again. Dave - W?LEV [email protected]> wrote: --

Dave, The original poster stated that he is using a TEKBOX TBTC2 TEM cell which is not an enclosed TEM cell.? Our lab referred to that type of TEM cell construction as a Triplate or Strip Line

Hi Otto, Dave and Eric I took a quick look at my new ZS-407 last night after reading your posts. I too have the the spur described with a terminated input. 533.775 MHz at -70dbm. I didn’t drill down

The TEM cell should be a completely closed Faraday volume. If it maintains its "new" integrity, there should be nothing leaking into the volume. I've used a TEM cell some 500-feet from a major cell

Southeastern VHF Conference 2025 Announcement & Call For Papers Quality Inn, 3095 Wilma Rudolph Blvd, Clarksville, TN 37040 April 4th and 5th, 2025 Papers and presentations are solicited on both the

Yes, I did notice some additional spurs in that tuning range that were at lower levels. Thank you for looking at that! ~Otto

Copy that and thank you so much. My test are to be sure the system is working correctly since I'm thinking about using it with a TEM Cell for EMC precompliance. Unfortunately I'm getting a strange

The worst spur is solved in my test setup, next I noticed some smaller spurs and now trying to get rid of these too -- Designer of the tinySA For more info go to https://tinysa.org/wiki

WiFi is often hopping frequency and you need to disable spur reduction to better see it. But with disabled spur reduction you will also see all kind of mirrors and spurs when doing such a wide