开云体育

reset the device, make sure the wires are connected securely, and repeat the calibration procedure. I had a problem like yours, it turned out to be a bad contact in the SMA. пт, 20 дек. 2024

Don't rush to buy spare parts, check the connection, take another wire. пт, 20 дек. 2024 г., 10:13 Takuo Watanabe via groups.io <wtakuo= [email protected]>:

Thank you, Erik. I'll try to buy an XA17-G4K (or AS179-92LF if that's not available) and replace U22 under the shield. It looks difficult for my aging eyes, though :-)

Looks like the input switch is broken See wiki FAQ for replacing the switch -- Designer of the tinySA For more info go to https://tinysa.org/wiki

I am using tinySA to test a channel power with center frequency 5.15235G and width 4M. I need to keep testing and saving data. How to set the center frequency and width of the channel power using the

I recently discovered that my TinySA Ultra fails self test No. 14. As you can see in the attached photo, it displays “Signal level Critical”. Another photo shows it failing Level calibration

Just got a reply from R&L and it seems that I won the honor of ordering the last old model. Will have to live with it. Thanks for your reply. 73 Roger Sent: Thursday, December 19,

Ultra+ logo on front of unit ________________________________ Sent: Thursday, December 19, 2024 10:51 AM To: [email protected] <[email protected]> Subject: Re: [tinysa] Pre-sale, tinySA ULTRA plus I

This is the ZS406 Ultra+ https://www2.randl.com/index.php?main_page=product_info&cPath=16_16990&products_id=76222 Look at the picture -- Designer of the tinySA For more info go to

I just got mine from R&L. I don't see ZS406 on the box or the unit. How would I know what version I have? 73 Roger KC7OM

ZS406 is also on sale at R&L in Ohio. John

New labeling. Current model is ZS-405. Newer plus models are ZS-406 and ZS-407.? ZS-406 is currently for sale at: Zeenko Hand held tiny Spectrum analyzer tinySA ULTRA+ 4" display with battery The

I was curious if there was a way to send the triggered state of the tinySA over USB. I would like to be able to monitor some specific bands trigger at some threshold then store the data and then send

Can you explain? [email protected]> wrote:

The version is shown on the label at the back.

does not work even when selecting no measurement occurs on firmware tinySA4_v1.4-189 чт, 12 дек. 2024 г., 16:46 Igor Feher via groups.io <igor.feher= [email protected]>:

Does the tinySA Ultra ZS405 have the ability to record data over an extended period, such as 5 minutes? Currently, it only seems to offer a capture feature for screenshots, but I want to log raw data

tinySA basic has same open bottom.

Hello, first-time TinySA user here. I got an ULTRA so not sure if this issue also exists in its predecessor. It came loaded with FW version 1.4.156 and the gridlines were rendering "properly", looking

Hi John, In his first post in this thread, Hugen stated: "... the ZS-406 will go on sale next week and the ZS-407 is expected to go on sale at the end of December." 73 Evan AC9TU