开云体育

Erik, Thanks for your suggestion. Unfortunately, after starting it with the jig wheel pressed to the left, there was no change. I forgot to mention that at the lower left corner a red "-110 dB"

The text "Path: HARM" is a remainder of an internal setting that should have been removed after the test/calibration. Switch of the the tinySA and on again and see if this is gone. If not, switch off,

I just received my TinySA Ultra. Earlier, I was able to get a clean sine wave on my Tektronix 2213A. I wanted to do a frequency correction as on the TinySA basic version. I connected "CAL" terminal to

Another issue with the app: when attempting to set the range to zero or scroll down to zero, the graph disappears. https://www.youtube.com/watch?v=wSA5phshMTA

Hi Erik The 189 alows running (sweep) again... The screen capture with refresh is a bit cranky... Thanks a lot for the fast reaction!!

hi Erik, It is working again, hartelijk dank 73, PA0MIK

New FW release Version V1.4189 For ZS405 (original tinySA Ultra) and ZS406 Changes: - Bug solved: TinySA-App can not control tinySA - Improved level correction table for ZS406 WARNING: This FW

Hi Not showing a scan on version 185.

Just tested it, tinySA4_v1.4-185-g1dd6b07 works too for me.

tinySA4_v1.4-177-g1687fbc.bin ( http://athome.kaashoek.com/tinySA4/DFU/old/tinySA4_v1.4-177-g1687fbc.bin ) works fine

/g/tinysa/topic/109991384 /g/tinysa/topic/new_fw_release_bug_fixes_and/109769305 Yes, this is an issue with the latest firmware version. Roll back to version 177; it

If you your <Start> frequency is set to 0MHz in tinySA-App, you will not see a display after clicking the scan buttons. Try setting your <Start> frequency to something like 0.1MHz and tinySA-App

Hi, Iwant to use a tinySA-ultra with the tinySA-App. By clicking on connect button tiny SA seems to be connected because single scan and multi scan buttons are highlighted. After clicking on one of

[ mailto:[email protected] ][email protected]?schreibt: @Theo B "Electric extension cords often have pin protections" How is this related to audio jacks? "What helps a lot to make that go smoother is

Which one works?

an isolated case of marriage, it is better to move on. I have not had anything broken in a couple of years and I used the minijack quite often, it is stupid to make a mountain out of a molehill. And

Thanks, Jim S. Dave - W?LEV [email protected]> wrote: -- *Dave - W?LEV*

You will think so until you break your Listen jack. How about being less judgmental of others' problems? Or mute the topic and move on. Святослав Маханьков via groups.io

roll back to the previous firmware. вс, 8 дек. 2024 г., 19:36 MaxPi via groups.io <avito.rassvet= [email protected]>:

Poor Eric, he reads this nonsense and tears flow from laughter. You created a non-existent problem. Maybe stop spamming? вс, 8 дек. 2024 г., 19:34 Jim Shorney via groups.io