开云体育

Thank you both so much for all the advice and for taking your time to explain the maths around power and dBm, this group and support around TinySA is so, so great! I now placed an order for TinySA

Hi You have wrapped several issues up into one topic, so let's see if we can unpick them. The first one is the static discharge issue. There are several ways around this, but the Ultra and later

Just be VERY careful to only buy from a recommended supplier! There are many inferior and illegal fake clones around….. https://tinysa.org/wiki/pmwiki.php?n=Main.Buying re the attenuator, 40dB 10W

Hello everyone, I'm looking to buy TinySA Ultra from Aliexpress and spent all day yesterday reading this group and watching Youtube videos. I must say I'm super excited! While it's an absolute

Thank you so much for the replies! I can't believe I overlooked the zero span. Thanks again!

Adjust the span to your needs, you can go all the way down to zero span that means it is a receiver on that frequency only. John

Use the 'Zero Span' option in the frequency menu. Regards, Martin

I apologize if this is a dumb question, but can the TinySA Ulta be set to a single frequency to monitor instead of scanning. I played with the menus but I didn't see anything obvious.

Thank you everyone for helping. [email protected]> wrote:

Thank you very much Erik !!!! Now with version 1.4-168 the selftest? is working correctly again !!!! Is it possible that you indicate all the changes that you have in this last version? I am very

And do not let the selftest complete but when it stops at a failing test, take a picture so I can see how it is failing -- Designer of the tinySA For more info go to https://tinysa.org/wiki/

Sorry, should be done now -- Designer of the tinySA For more info go to https://tinysa.org/wiki/

--->>>> tinySA_v1.4-166-gcb33f64.bin fails in test 5 and test 6. where do you download version V1.4168 ??? it is not published:

I've tested FW V1.4168 and don't see a problem with the selftest Can you post a screenshot of the failing test instead of only the final screen -- Designer of the tinySA For more info go to

Good morning, I had to go back to version 1.4-159 to get tinySa working properly again. I hope this information will be useful to review the latest FW. Thank you.

Seems the LNA is no longer functioning. -- Designer of the tinySA For more info go to https://tinysa.org/wiki/

Yes, on both devices -- *// LMA // * RF Coordinator for live shows

Hi Erik and thanks for the answer This is a capture with the LNA active This one without the LNA Thanks! -- *// LMA // * RF Coordinator for live shows

If you previously did run a very old FW then yes, many changes have been made. But in the latest couple of releases there should have been no changes to the selftest -- Designer of the tinySA For more

Yes, it is easy, I just try it with a serial port assistant like that.