开云体育

Strongly recommend running a self-test BEFORE firmware update for baseline. Peter

Hello All, This has been discussed multiple times in the group but it is worth raising it again. On both of the TinySA and TinySA Ultra firmware download pages on Erik's website, there is an

Github issues #99 and #100 created.

I have found many neat uses for my Ultra and find the capabilities quite rich and the device very easy to use and configure. Thank you! I do have a couple suggestions around file management. Perhaps

Should match the HW version number on the label on the back of your unit - mostly. I had the 4.5.1 on the display like you and on the back the label had HW Version V0.4.5.1.1

Installed with no problems, all tests passed.

Somehow I got an email? asking how I? did the updating. As I have confused two programs in my PC, it is best to answer here. I used STM32CubeProgrammer First you need STM32CubeProgrammer, mine is a

Excellent. We have a lot of those around here, and probably the rest of the UK too. The 458.525 to 458.925MHz chunk of spectrum (also 869.40 to 869.65 MHz) used by them, seems to have evolved from

Hi, Just thought I'd let you know that I finally made use of my TinySA Ultra tracking down some interference where I work with some testing equipment. Using a handheld yagi I made for 70cms I tracked

Should be the HW version -- Designer of the tinySA For more info go to https://tinysa.org/wiki/

Thank you. I just installed the FW with Win7 and ST-link utility. But what are those 4.5.1 letters below the current FW version number? Are they remnants of the previous version? Regards .

No, higher modulation frequency is not possible -- Designer of the tinySA For more info go to https://tinysa.org/wiki/

I noted that the Maximum available FM modulation frequency of the RF generator is only 3.5 kHz. Even if I set, for example, 10 kHz, the generator sets to 3.5 kHz anyway. Having to test a broadcast FM

here it is an example, if you need everything else just tell me

Add the ability to save and restore Signal Generator Configuration to SD card. Suggested Implementation: Use a different filename suffix for saved Signal Generator configuration files versus Spectrum

Good catch, thanks -- Designer of the tinySA For more info go to https://tinysa.org/wiki/

Issue #97 opened.

Did you forget to connect the SMA patch cable between the two ports? Does your unit also fail calibration? proton.me@groups.io> wrote:

This new - and every - firmware update works well with my ultra. I update it with dfusedemo, under win10. Thank you Erik for this very good measurement unit! 73, HA3MG

Edition??? Windows 10 Pro Version??? 22H2 Installed on??? ?9/?28/?2020 OS build??? 19045.4046 Experience??? Windows Feature Experience Pack 1000.19053.1000.0 I was running