开云体育

He is measuring the maxhold of a frequency sweep to try to see the flatness of the level measurement over frequency -- For more info on the tinySA go to https://tinysa.org/wiki/

The correction tables are generic for all same model tinySA and may improve over time. Unless you have created your own correction tables, you should never need to save/restore them over a FW update

What are the characteristics of the input signal? -- For more info on the tinySA go to https://tinysa.org/wiki/

Depth error is a warning that with the currently requested output levels there is insufficient headroom to perform the requested AM modulation. The device is not faulty but you are running into a

Hello, I don't have a clue what you try to measure or demonstrate. I can't identify any signal. Can you please tell us what signal you measure and what you expect? All the Best, Isidro Am 04.03.2023

The measurements continued. 1 swiping cycle of source took 1000 seconds. Accumulated 4 cycles:

Thank you. I seem to have missed this thread. There was a question on correction. Is it worth using the previously recorded correction factors in the new firmware?

/g/tinysa/message/8079

коррекция низкая 0 10000 14,2 коррекция низкая 1 40000 9,5 коррекция низкая 2 100000 7,6 коррекция низкая 3 300000 3,8 коррекция

Bit better, but:

What means: DEPTH ERROR? Modulation works but writes this error this error was at the time of purchase. you said that the device is calibrated and corrected in production. but as soon as I received

Can you test the tnySA Basic with setting display/sweep accuracy/presice Hopefully the spikes will be gone -- For more info on the tinySA go to https://tinysa.org/wiki/

Thanks for the quick explanation. If I understood correctly, then this is not the actual problem, but the consequence of the problem. There is another difference between these two devices, clearly

Eric, In the wiki this link: For Ultra owners, there is a different Kurt Poulsen video ( https://tinysa.org/wiki/pmwiki.php?n=Main.UpdatingTheFirmware ) that provides an overview of getting started

U13 was reserved for a solution for a problem that went away with the latest layout. -- For more info on the tinySA go to https://tinysa.org/wiki/

tinysa ultra, what did you plan to put the u13 chip on the board?

The red "AM" warning signals a signal above a certain level that has large amplitude changes as these can confuse the level detector Once active a user action? or display status panel update, such as

I have this problem on tinysa ultra.

I have 2 tinySA2.8. One works fine, and the second often lights up the indication of the red letters "AM". In this case, the measurement mode is DISABLED. From observations: In the absence of a

I recently purchased the Ultra for installing an OTA TV antenna for a neighbor.? I set two ranges in memory, one for high VHF and the other for UHF OTA frequencies.? After installing the antenna I