开云体育

Then I can adjust the "SWEEP TIME" to a higher value and thus have a slow sweep and with that select "pause".

Erik. I have a commercial transceiver (display shows channel number). So I need to figure out the RX frequency for each channel. For this I use the RF + SWEEP generator function to generate RF in a

david, super job, helping all of us to better understand our new “ toy “ per your wife, give her a hug ans tell her it is fun and a learning process. , again many thanks.

Hi David I am absolutely new to Visio and are looking into how to get going. I looked at Microsoft Visio and it confuses me as it look like a different kind of my Office 365 and to be available end of

Hi David, Great work. Can I suggest you use the "save as type" .pdf option in Visio ? This will allow almost anyone to open it without needing to run Visio, and it will even work in a web browser or

Hi Kurt, I hadn't realized how complex this little device is until I started this documentation process!? I would appreciate and encourage any assistance in expanding and improving this

Thank you Larry, Mint does recognize the TinySA but the TinySA Saver does not. I did try everything in any forum I could find, all the Linux Mint forums had to do with. Mint did not recognize the USB,

I had that problem with a $50 HP chromebook running LINUX Mint -- only my USB device was the chromebook sound card. I took a deep dive into LINUX-MINT and found that not all possible drivers are

i've done it with a TinyVNA and written it up over a year ago . My comments are all over at [email protected] including how I overcame the 70dB dynamic range using an inexpensive 23dB wide band amp. I

Nice work David!

Very impressive and helpful.? Well done. Wes? N7WS

I am looking for help please, I am running Linux mint, I installed tinysa saver and the program loads but it does not recognize the tinysa usb port. I ran lsusb and Mint does recognize the tinysa is

Hi David Very impressive work you have done, and it demonstrates how very complex a product TinySA ULTRA is. The last page about signal generator are also an area to expand and equally complex. If you

The following files and folders have been uploaded to the Files area of the [email protected] group. * /Visio-TinySA Ultra Menu-Tree Chart - v1.4-40 - Updated January 16, 2023.pdf (

Hi Anthony You may need to use both a VNA and a TinySA ULTRA as the dynamic range of the VNA might not be adequate for tuning the deep notches pending how many sections your duplex filter has and what

I'd like to make a general suggestion to anyone on this group and the NANOVNA group: Dig just a "bit" and learn the differences between a Spectrum Analyzer and a Vector Network Analyzer. It isn't

With only a tinySA you can not tune a duplexer as you also need a source. With two tinySA you can tune a duplexer but the tuning process will be slow Best would be to use VNA -- For more info on the

Excellent suggestion -- For more info on the tinySA go to https://tinysa.org/wiki/ex

Hello David, Thank you for the very detailed Menu tree. But it looks to me that the TRACE->CALC branch is missing: https://tinysa.org/wiki/pmwiki.php?n=Main.MenuTree * *CALC state* (