开云体育

Merry Christmas Erik! de Tim K4SHF

Hello Eric, I did read the Wiki and I do know about TV modulation. Anyway, here is a new picture showing Trace 1 as LIVE with SPUR REMOVAL diabled and Trace 2 as HOLD.with SPUR REMOVAL enabled: As can

Merry Christmas Erik I hope to have my new ultra this week or next week, as it is now in the UK Thanks Dave 2E0DMB

New ULTRA FW release Version V1.4-8 Changes: - Added SD load/store trace table - Add SD load trace, this sets the span to the loaded trace and enables the trace These new functions have seen only

Vitor, A TV modulation is typical a broadband signal and as you know (you did read the wiki page on Ultra mode?) this could create some problems. Can you disable CONFIG/SPUR REMOVAL and try again what

Eric asked about use cases for frequecies >10GHz. Well, here is mine! I am, among other things, a satellite DXer and interested in satellite TV reception. In order to get fringe reception going and to

Hi Roger Your calculation is not fully correct as when sung a span of 120MHz (118MHz) your noise power is directed to the mixer via the 800MHz low pass filter so the math is 10*log(800E06) = -88 + 89=

Thanks! That fixed the issue. The software is already working with the TinySA Ultra - some extra functionality needs to be implemented, but overall the TinySA Ultra rocks! Regards, Vitor

/g/tinysa/message/8521 -- For more info on the tinySA go to https://tinysa.org/wiki/

Hello, Merry Chrismas everyone! I finally was allowed to open my Christmas present: the brand new TinySA Ultra. Got up early and while eveybody is still asleep, I adapted my "VMA Simple Spectrum

New tinySA3 FW release Version V1.4.7 Changes (thanks DiSlord) - Improved defaults for the touch parameters so after FW update you still can use the touch to activate menu's - Moved touch calibration

Missing link; https://www.youtube.com/watch?v=QVNtAP3zGLc Cheers.

Sorry Erik, video removed and replaced according your recommendations! ( 16 views ) https://www.youtube.com/watch?v=QVNtAP3zGLc My mistake, i thought it was public domain since Imsai G has these

Recalibrate touch, use leveler buttons for enter in menu Push leveler for enter in menu after use left/right and push go CONFIG->TOUCH->TOUCH CAL And touch on * as say on screen

Max, Would it be possible NOT to show the ultra unlock code in a public video? I really would like people to visit the wiki ultra page and read the disclaimers about the limitations of the ultra on

here you go Mike! https://www.youtube.com/watch?v=z3sMjJIjmnU Cheers Max.

Merry Christmas to you too Max. Watched your video, great job. My question is on the site but I'll reiterate it again here. How do you set the Ultra up to read 10GHz? I'd really appreciate some help,

Follow up to my last post.? Below is a s21 plot of a Para Dynamics low pass TX filter that was done using a NanoVNA-H4. One method to measure a filter with a tinySA is to use a Noise Generator (NG)

Hi The Boss Merry Christmas to you too I will do this when mine has arrived, Thanks Dave 2E0DMB [email protected]> wrote:

Merry christmas, uploaded a new video on how to correct the ultra's frequency. https://www.youtube.com/watch?v=VyjGSFjtdCU Cheers.