开云体育

Further testing shows that self tests 1-9 will pass with leveloffset low values between 0.2 and 7.3 Test 10 still failing.

Pictures: Level 0.0 Level 8.2 (As set by Level Cal) Level 6.0

Herb, Set all values as per your post. Results: If leveloffset low set to 0.0 , test 3 fails with "Signal level critical" If leveloffset low set to 8.2 (value set by Level Cal), test 3 and test 4

David, Erik used precision components in the production level tinySa and some of the Wiki content may not reflect current correction table values. Before you updated to the new firmware version you

I noticed that the wiki shows two different values for correction table slot 4. Under firmware update it shows a value of 50000000 0.0? Under USB command: correction it shows slot 4 as 30000000 0.0

leveloffset low 7.7 leveloffset high 100.0

What is the value of low and high leveloffset?

Picture:

SMA appears to be okay, Level calibrate completes OK.

Please post pictures of the failing tests (screen captures or use camera or phone) so I can diagnose the problem Make sure the coax SMA connectors are well fastened, use only your fingers for

New Tiny SA received yesterday. Unit came with v1.0-39. Updated using .dfu file to v1.0-49. Reset and cleared the configuration data, restored settings per wiki instructions. Self test reports Test?

Yes. I need to spend some time on tinySA.exe

Erik, I updated to the latest TinySA.exe and noticed the following issues that would be confusing to new users. My system is a DELL laptop running WIN10 x64: 1. Every time I start the program I get

I did not.? Luckily I have one from my NanoVNA.? That cable works. Thank you for your help. 73 Evan AC9TU

Hi Evan Did you also test using another USB cable ? Kind regards Kurt Fra: [email protected] <[email protected]> P? vegne af Evan Hand Sendt: 10. august 2020 13:20 Til: [email protected] Emne:

I assume you did try a different USB cable and the tinySA was switched on when testing the connection? Is the red led next to the USB connector blinking and the battery charging?

I did check on the Device Manager for the port.? I did not see the TinySA or a port that could be the TinySA (an unknown port).? I did this for 5 different computers. Evan

I added some connection debug info to the wiki https://tinysa.org/wiki/pmwiki.php?n=Main.PCSW Scroll down till the part related to the windows device manager and follow the instructions. I

Erik, I now cannot get the TinySA to show up on any of the 4 Windows10 computers that I have tried.? ?As I stated in my first email, it did respond for a short time after I rebooted my computer.?

A new tinySA.exe is available that automatically sets these to the right value. If you loose connection, unplugging the tinySA USB and plugging back and?exit and restart tinySA.exe should be