开云体育

Just as an aside my new model 407 recently arrived with V1.4-192 FW installed, now upgraded. Dino KL?S

I had a similar failure, also coincident with an upgrade, which left me with a white screen. Re-seating the cable restored the correct display. Best regards, Don Brant

That did it thank everyone for the suggestions especially Erick. Happy to be back in operation.

Thanks Erik for your effort and for the confirmation that its seams to be a real issue and not only based on my fault in operation. Markus

Try reseating the LCD cable, this has helped several people -- Designer of the tinySA For more info go to https://tinysa.org/wiki

Markus, Its best to copy/paste picture, not attach. Thanks for bringing this to my attention. I understand the issue and there may be a solution however the possible solution needs a lot of testing to

already tried that several times and several older versions with no luck.

Dear Eric, thanks for clarification concerning the usable FW for the ULTRA+ SA. In my exported spectrum from QtTinySA the LNA was enabeled when using FW -196-. I give it a try to attached again the

go back to an older version and see if that works.

No, Release V1.4-195 is the first public release FW which is suitable for the ZS-407 When you buy a ZS-407 it may contain an older FW version but that may a special version created before production

Tried suggestion but no change still no touch screen function and no menu displayed. I recall seeing the word touch displayed in the top righthand corner of the display when it flashed several times

Dear Erik, one additional question, in order not to cause confusion with the mentioned observation. Could you confirm, that FW version tinySA4_v1.4-175-xxxx could by used with the ULTRA+ as in the

Sorry - reply was addressed to Erik not to Eric! Markus

Hallo dear Eric, sorry I mad proper pic's but the import to the forum reduced the image resolution. What concerns the test parameter, please se below. (center 500MHz, span 10kHz, RBW 1kHz) The

Ha, For that sort of scenario, I once made my own Nonlinear Junction Detector (NLJD), based on a pair of Motorola Analogue cellphones placed in "Engineering" mode by internally strapping the battery

I use a baby monitor app when I’m tuning my home antennas. The app is called Baby Monitor. It can use audio, video or both. I have the app on my iPhone and iPad. In the shack I put the iPad in baby

And do mention in words what you consider a problem -- Designer of the tinySA For more info go to https://tinysa.org/wiki

Sorry, I can not read span/center or start/stop/rbw numbers -- Designer of the tinySA For more info go to https://tinysa.org/wiki

Hi TinySA experts, I'm observed an issue comparing the Ultra+ (ZS-407, V0.5.4) vers the old ULTRA (HW V0.4.5.1.1). I purchased two devices of both HW Versions, so my tests were run on four

Bravo Martin. After 13 years of locating clandestine communications equipment, I realized not every scenario required state of the art equipment and knowledge. I had a friend in a similar situation