开云体育

On Tue, Jun 23, 2020 at 11:11 PM, Terry VK5TM wrote: Even with reading glasses I find the screen of the NanoVna too small, so it's not getting used at the moment until I can sort a better

There is already,

I almost always use my nanoVNA in the shack and connected to the PC with the nanoVNA saver program, much more convenient operation not only by the screen size. I suppose that there will be a similar

It is just a matter of good reading glasses. Also in my age of 72 it is possible to read that 2.8 inch display of the nanoVNA. I think the price is important. The lower the cost, how more toys you

You will have to wait for the 4" version.

Even with reading glasses I find the screen of the NanoVna too small, so it's not getting used at the moment until I can sort a better solution. -- Terry VK5TM https://www.vk5tm.com

Dear Dick, I am assuming that people with reduced eyesight already have reading glasses lying around everywhere, at least I do.

Does it come with a magnifying glass ??? 73, Dick, W1KSZ ________________________________ Sent: Tuesday, June 23, 2020 9:40 AM To: [email protected] <[email protected]> Subject: Re: [tinysa] TinySA

I want one !!! >:o -- El software de antivirus Avast ha analizado este correo electrónico en busca de virus. https://www.avast.com/antivirus

As the tinySA FW and HW are nearing completion I made a short introduction video that is available here ( http://tinysa.org/video/intro.mp4 )

The testers have been asking for some extra functionality and it was still possible to fit it into the available space. Here you see two functions in one picture. One tinySA is used as signal

Thank you and good luck :) A sábado, 30/05/2020, 09:14, Erik Kaashoek <erik@...> escreveu:

A small status update. Progress is good. The performance measurements by the testers is confirming the specification and the user interface has been updated based on user feedback. Preparations for a

Measuring the 1dB compression point is a lot of work as you manually have to step through many signal levels to find the level where the detected signal is 1dB below the expected level. Using the

Next to the performance of the first LO and the first mixer, the performance of the various resolution filters does have a huge impact on the performance of a spectrum analyzer. To provide some

One of the beta testers did a very good job at measuring the power linearity of an uncalibrated tinySA. Uncalibrated implies the absolute level may be a couple of dB off but the relative steps should

I write all info about in NanoVNA group in my firmware topic /g/nanovna-users/topic/nanovna_firmvare_compiled_by/73181877 For transfer data need eject SD card from slot and put in PC

Dislord, Will your SC Card support also include transferring stored traces to a PC?? What formats do you anticipate being a to store to the SC Card? - Herb

Will be a good solution for a future 4" version of the tinySA. In the 2.8" version there is not enough spare space at the edge of the PCB to place the SD cardslot

At this moment i implement SC Card support for NanoVNA H4, it very simple and good work. Use SPI interface some as display, need only SD_CS,?SPI_MOSI,?SPI_SCLK signals (SPI shared vs display and