开云体育

Harm curve editing is already present in the latest FW It is missing from the manual. -- Designer of the tinySA For more info go to https://tinysa.org/wiki

Hi Toni, Your video is really interesting. May I know what type of antenna you're using? It looks handmade. I don't have much knowledge about antennas, but theoretically, if I have an antenna similar

Could this be released in a Flatpak for Linux? Regards, Jason

Hi Tony, Now that I am back from holiday I have created issue #67 ( https://github.com/g4ixt/QtTinySA/issues/67 ) for this bug and I will fix it.? Thanks to everyone who confirmed the problem on

With battery and USB disconnected and toggle pushed to the side the tinySA starts a new life so I have no clue what happened. -- Designer of the tinySA For more info go to https://tinysa.org/wiki

It's an illegal (partial?) copy of the hw and this group is not the place to get information or support. Therefor I will close this topic. -- Designer of the tinySA For more info go to

I was scanning the GMRS frequencies (462.5625 through 462.7250 Mhz) for a few minutes using the provided antenna, when my screen locked up. * Tried restarting device.? Got the "Starting up..." and

https://trademarks.justia.com/984/41/portxvnsa-98441717.html

Thank you so much for your support. The code works perfectly.

I see it also lacks reference to the tinysa.org page and the scan code.? Its likely that saying their statement, "designed by ERIK in Netherlands", to too vague to have any legal clout, but still is

No need to wait: https://www.amazon.com/Rigol-DSA815-TG-Tracking-Generator-Spectrum/dp/B00CLWJA38 -- Designer of the tinySA For more info go to https://tinysa.org/wiki

be nice if the cal output could also be a tracking generator be nice if the input more indestructible, I like my tinySA but have anxiety.?? LOL I'd like my test equipment to survive my mistakes. I

thanks very much [email protected]>) escribió:

Treat with the usual suspicion …

Its a clone and I'm not involved. -- Designer of the tinySA For more info go to https://tinysa.org/wiki

Hello, I have seen a proposal for a? spectrum analyzer called SA5 on the Banggood web site (french version). Looking at the features show that it sounds as an Ultra SA (or not). It is sold on the

Measure the call output with LNA on and LNA off It should be around -35dBm If the level is about correct with LNA on then you probably blown the attenuator If the level with LNA on is as bad as with

1uF -- Designer of the tinySA For more info go to https://tinysa.org/wiki

Hi, please i need help , wich is the value of C58 capacitor? , is in short circuit , i replaced lna chip, the input switch and attenuator too, all test run ok , but measured this capacitor reveal is

Hello everyone. I had a similar problem. Unscrewed four screws and open the case. The large cable fits well. The small one from the touchscreen goes under the display, I lifted the display slightly