开云体育

Thanks for the quick response, In my troubleshooting of the issues i did upgrade the firmware to the latest version without problems. Here are the results for test 7

I put a layer of clear packing tape over the label and trim it to size with a sharp xacto blade. It won't protect from leakage around the edges but it protects the important stuff nicely. 73 -Jim NU0C

Whenever I get a new item, I start a directory in my computer for its manual, and anything else important about it. One of the things I do is photo the plates like that and put that photo in the

Thanks for the 'Heads-Up'.

Well, I just removed part of the label ink on the back of my TinySA Ultra while wiping the back with isopropyl alcohol!? The ink used on those labels is NOT permanent ink when it comes in contact

Thanks for reply. (always learning)

Greetings Erik, Many thanks for finding the time to respond and most of all for what you do! I finally determined that the 15 measurements displayed were the last 15 of the sweep. It turned out the

Once you enter a fourth digit a space appears.? I think this space would have a comma if you were entering a numeric value greater than 999 like for a frequency but not a PIN code number.

Why does your first picture show a space between #1 &#2 in code entry? I thought there were no spaces.

After I clear config at LEVEL CORRECTION --> OUTPUT LEVEL --> 30MHz Level I read value about? -44.97dbm this is normal ?. And I? enter this value and next step to 1GHz level system is show? error

Thanks for you replied, Now I clear config all done and I try to re calibration? ?but still have a problem see my picture below.

Disregard my last message, as I forgot you said that you 'successfully' did an update on the unit.

Where and when did you purchase? I somewhat remember someone saying to me that the #7 test will reveal a clone, as it can not successfully go thru this test.

Test 7 below also, I updated the firmware to the most current version in an attempt to correct the calibration issue. Got the same results as before. -- Scott Nolde

Steven, Thanks from me as well. I always thought (wrongly) that the NanoVNA-H4 was sub to the VNA-F. I guess I liked the larger screen and updated 5000mA battery install options by the sellers. I was

Hi Ed the SW gor the TinySA works only with the NanoVNA-H4 the SAA-2N or NanoVNA-F are different in the hardware, it would not be possible to use this devices. Erik has a forum on the website he send,

I AGREE........on the thought. Anything that can help us all out here, when it come to full utilization of the TinySA, is not 'OFF Topic'................

Printed with PLA. I haven't tried PETG yet. And yes, "Supports Everywhere". The hinge supports actually remained on the print bed when I removed the print. The attenuator support easily and cleanly

Hell, back in my day LPUO meant to not pick up any foreign women going out on a date.

Hi Scott Eric need always selftest no 7 ;) This can be created using a serial over USB command selftest 0 7 with this test he knows clone or not a clone, if it is a clone (normally the original TinySA