开云体育

Maybe I will add a config switch to disable REMEMBER STATE. -- For more info on the tinySA go to https://tinysa.org/wiki/

Did you try to press the jog wheel? Try to reduce pressure from the case on the screen by relaxing the 4 screws Maybe the pressure causes a false touch -- For more info on the tinySA go to

It took me a few failures to boot before I realized I was building for the original TinySA and had to figure out how to switch to the Ultra. Once I figured that out, editing DISPLAY_ROTATION_*,

Just received mine from R&L. Did the firmware up grade and calibration. It worked fine yesterday. Today when it boots up and I touch the screen it defaults to the frequency setting screen. The only

High and Low are from nanoVNA. ;-)

Picking up on Michael Brun's second question, and without knowing the requirements for programming, I dare to suggest that the SAVE AS STARTUP menu could include a check box (i.e. called LAST STATE),

There are several ways to update the firmware and the tinySA Wiki on this procedure describes several ways to do it. https://tinysa.org/wiki/pmwiki.php?n=Main.UpdatingTheFirmware The link I provided

*** Post edited with correct links On Windows 7 you will need several things for your Ultra. * A serial COM port driver so that you can exchange serial data with a PC app *

Yes that is an error in the TinySA Ultra menu.? Erik will probably do an update before too long. Roger

Bill, The Ultra is a complete circuit re-design and does not use high and low ports.? I Roger

In the line ... "SELF TEST is used after a cable is used to connect the low and high input/output." Shouldn't that read ... "SELF TEST is used after a cable is used to connect the RF and Cal input."

Ultra has always used CAL and RF as port names -- For more info on the tinySA go to https://tinysa.org/wiki/

I just received an Ultra via R&L.? My HW version is V0.4.5.1.? I noticed that the ports on the left side are labeled differently from what I have seen in videos and images.? The top one is labeled

*SELF TEST *

Hi, Mine arrived too. Actually it arrived Friday but our post office has limited hours and I could not get there until Monday. I put it on the battery charge for a while before turning it on. The

My TinuSA Ultra. Super.

Let me try to conclude this thread The SW for both tinySA is largely the same source. The current tinySA group is a free legacy group that does not allow subgroups. I do not intend the create a new

Hi, first of all, I don't see reason to split the discussions at all. Most of the questions arise are not really bound to the TinySA or the Ultra. Also because the firmware for both units are planned

Hi Josh, to have a better and faster result you can use a noise source or a tracking generator in many measurement setups.. Both have different advantages or disadvantages. If your test setup includes

Stereo -- For more info on the tinySA go to https://tinysa.org/wiki/