开云体育

I want one !!! >:o -- El software de antivirus Avast ha analizado este correo electrónico en busca de virus. https://www.avast.com/antivirus

As the tinySA FW and HW are nearing completion I made a short introduction video that is available here ( http://tinysa.org/video/intro.mp4 )

The testers have been asking for some extra functionality and it was still possible to fit it into the available space. Here you see two functions in one picture. One tinySA is used as signal

Thank you and good luck :) A sábado, 30/05/2020, 09:14, Erik Kaashoek <erik@...> escreveu:

A small status update. Progress is good. The performance measurements by the testers is confirming the specification and the user interface has been updated based on user feedback. Preparations for a

Measuring the 1dB compression point is a lot of work as you manually have to step through many signal levels to find the level where the detected signal is 1dB below the expected level. Using the

Next to the performance of the first LO and the first mixer, the performance of the various resolution filters does have a huge impact on the performance of a spectrum analyzer. To provide some

One of the beta testers did a very good job at measuring the power linearity of an uncalibrated tinySA. Uncalibrated implies the absolute level may be a couple of dB off but the relative steps should

I write all info about in NanoVNA group in my firmware topic /g/nanovna-users/topic/nanovna_firmvare_compiled_by/73181877 For transfer data need eject SD card from slot and put in PC

Dislord, Will your SC Card support also include transferring stored traces to a PC?? What formats do you anticipate being a to store to the SC Card? - Herb

Will be a good solution for a future 4" version of the tinySA. In the 2.8" version there is not enough spare space at the edge of the PCB to place the SD cardslot

At this moment i implement SC Card support for NanoVNA H4, it very simple and good work. Use SPI interface some as display, need only SD_CS,?SPI_MOSI,?SPI_SCLK signals (SPI shared vs display and

And some practical?examples First DECT traffic just below 1.9GHz and second WiFi traffic around 2.45GHz. Red line is current signal, yellow line is power envellop

Having full control over the internals of the tinySA allowed some experiments at higher input frequencies using the mixer and BPF in a creative way. This of course required the elimination of the low

I will adapt the wiki to show the status of the availability of the HW

Thank you all that responded. I only wanted to be sure that the hardware was available or still not. Since I read a lot of messages in the group I was not sure if I had missed the launching

I have been in product development of high volume electronics (millions of products sold all over the world) and experienced a major post launch problem forcing a global recall. Launching too early is

The usual response to questions like that regarding products still in development is:? "It'll be ready when it's ready."

Shipping times are terrible and not all beta testers have received the HW yet. Once they have access we have to wait for their feedback.

Hola Ignacio, I have made the very same question today! And because of the same reasons... Anyway, I was redirected to: /g/tinysa/message/99 *73 de Luís, CT2FZI* *QRV @ 145.300