开云体育

Close... https://www.everythingrf.com/rf-calculators/antenna-factor-calculator

Anybody used PCTEL OP451 ( 450 MHz – 6 GHz, VSWR <2.0:1, 50 Ohm ) wideband antenna with TinySA Ultra ? It is a good match? Anybody had any experience with this one or a similar antenna? Pros and

Well that wasn’t very smart! ?Yes, I’ve found the correct page now - thanks.

You are reading the tinySA basic spec, try the tinySA Ultra spec -- Designer of the tinySA For more info go to https://tinysa.org/wiki

I'm trying to use the signal generator again, as I have many times.? But I'm looking for a bit more power than before.? I see that it is specified (at

Did you read the change log? -- Designer of the tinySA For more info go to https://tinysa.org/wiki

I 'll ask the question in a different way. There are versions in the tiny SA Ultra line ( ZS - 405 , ZS - 406 , ZS - 407 ) that probably differ in hardware. The latest versions of the software are

That's only with the FW release after the introduction of the Ultra+ If you run older FW there is no indication. Just tinySA Ultra, which means ZS405 -- Designer of the tinySA For more info go to

Hi in config, version, it is on the first line.....

These limits have indeed not been tested. -- Designer of the tinySA For more info go to https://tinysa.org/wiki

I agree with what has been said, done numerous updates no probs. Always do a self test prior to an upgrade, else if you have damaged the unit, you may think it was due to the

Hi. If you connect the tinySA Ultra computer to the tinySA APP program, you will see this information in the log window.

Generally as Clyde says make up your own mind. Once you have done on a couple of updates there is no stress, providing care and basics are considered. Always fully investigate that others that have

Update your firmware then look at the version info. It was part of firmware update a while ago.

The older models do not have the model on the front of the case. For older models, before they started using the Z S series as designation of model, the lable on the back of the TyniSA will tell

From the photo on the wiki we see this - look at the top bar of the case, along with Ultra+ in the bottom right logo:

My question was where do I determine which model I have? I know they are different. Dave - W?LEV [email protected]> wrote: -- *Dave - W?LEV*

I plan to leave this unit outside, 0 to +40 deg C.? it may have to go inside an enclosure which would bring the high temperature up to 70 deg C.? It sounds that these limits are untested?

Hi. ZS405, ZS406, ZS407 are all different tinySA ULTRA models.

Dumb question, but: Where do I find the ZS-405, 406, or 407 in/on my TinySA/Ultra. It's not under "Version". Dave - W?LEV