开云体育

Yes, I did enable it and it switched to ON.

You have a transmit antenna? (Can be a bit of wire fitting loosely in the low out connector.) Modulation on? Audible modulation frequency selected? Ron Hartikka hartikka@...

You have a transmit antenna? (Can be a bit of wire fitting loosely in the low out connector.) Modulation on? Audible modulation frequency selected?

Rich, a picture*^? * is worth a thousand words, so here is the culprit, taken from the LOW OUTPUT operational screen: Low Output operation screen image Note that the output is *OFF* by default on

Really stupid question but... Did you enable the output by clicking the "LOW OUTPUT" button? -- For more info on the tinySA go to https://tinysa.org/wiki/

Hi all, I'm new to TinySA, but am loving my new SA. I have had no problem with scanning input, but I tried for the first time to generate a frequency using the Low Output mode, and my RTL.SDR on my

Erik, the developer of the tinySA made a video showing how to do this.... https://www.youtube.com/watch?v=Oo-oHaO9ang Check out his other interesting videos here >>

Hi Guys, I'm a little skeptical to try this for fear of blowing the tinySA front end, but can the output of, say, the liteVNA64 be inputted into a mixer then into the tinySA to extend the SA's

?Christian, You’re absolutely right - I didn’t realize that you can select what to step with the jog switch. Very useful indeed! I guess I need to review Erik’s videos to see what else I

(1) might come from a misunderstanding what "JOG STEP" actually does. By touching the very bottom of the screen, you can select that the jog dial controls start, stop, center frequency or span instead

Much appreciated -- For more info on the tinySA go to https://tinysa.org/wiki/

I've been exploring the menu, and think I've found some other behaviors that seem improper. 1) The JOG STEP function doesn't work as expected. When set to anything other than Auto, it seems to always

Its a known problem which I did not yet give enough priority to solve -- For more info on the tinySA go to https://tinysa.org/wiki/

Can confirm this behavior (tinySA_v1.3-347-g31eb02e): I see this white line when clicking BACK in one of the following menus: - LEVEL - TRACE - MEASURE - CONFIG To me it looks like the problem only

Hardly worth mentioning, but some menus: LEVEL, TRACE and CONFIG, and some submenus, leave a line just beneath the grid when BACK is selected. (Ver. 1.3347)

Thank you. And sorry for causing you additional work with the second PR just now. Regards Christian

Yes. Github is the right place. Will react. -- For more info on the tinySA go to https://tinysa.org/wiki/

Hi, I recently posted a "pull request" on GitHub: https://github.com/erikkaashoek/tinySA/pull/27 ... to fix two (minor) bugs that I encountered in firmware v1.3-347:

Erik, Toni @ Martin, I didn’t realize that low-Z phones are sensitive enough. I just tried a pair connected in series, and confirm that volume is adequate, and that a 3.5mm jack would be preferable

Another method of mounting a 3.5mm socket. /g/tinysa/message/4045 Regards, Martin