开云体育

ctrl + shift + ? for shortcuts
© 2025 开云体育
  1. Repeater-Builder
  2. Topics

Cellwave 526-4-2 harness specs

 

I have a cellwave 526-4-2 here and I'm attaching a picture that basically shows the issue. I need to make a whole new harness for it including antenna port harness.

Can someone point?me in the right direction for harness specs, cable type and length for 440-470 mhz?

I need to make the antenna port jumper harness as well as the individual cavity harnesses.

Idk what the jackass before me was doing but they butchered the harness.

Thanks

Robert
 

开云体育

  • I have a cellwave 526-4-2 here and I'm attaching a picture that basically shows the issue. I need to make a whole new harness for it including antenna port harness.

?

RG214.? Between cavities – 11.5”.? To antenna tee – 12.0”.? Those are tip-to-tip lengths for 440-470 MHz range.

?

??????????????????????????????????????????????????????????????????????????????? --- Jeff WN3A

?
 

Thank you,

You just saved me a major headache.

Robert

On Thu, Apr 10, 2025, 7:34?AM Jeff DePolo WN3A via <jd0=[email protected]> wrote:
  • I have a cellwave 526-4-2 here and I'm attaching a picture that basically shows the issue. I need to make a whole new harness for it including antenna port harness.

?

RG214.? Between cavities – 11.5”.? To antenna tee – 12.0”.? Those are tip-to-tip lengths for 440-470 MHz range.

?

??????????????????????????????????????????????????????????????????????????????? --- Jeff WN3A

?
 

?Looks like you just need a N type T connector and one length of jumper
Neal?




On Thursday, April 10, 2025, 9:37 AM, Part 15 Engineer via groups.io <kc8gpd@...> wrote:

Thank you,

You just saved me a major headache.

Robert

On Thu, Apr 10, 2025, 7:34?AM Jeff DePolo WN3A via <jd0=[email protected]> wrote:
  • I have a cellwave 526-4-2 here and I'm attaching a picture that basically shows the issue. I need to make a whole new harness for it including antenna port harness.

?

RG214.? Between cavities – 11.5”.? To antenna tee – 12.0”.? Those are tip-to-tip lengths for 440-470 MHz range.

?

??????????????????????????????????????????????????????????????????????????????? --- Jeff WN3A

?
 

Butchered and jackass….. ?NO.?

it looks like they had made a 6 cavity preselector using the 6 pass/reject cans in series with notches on both sides of the pass frequency. ?This is one way of making a narrow passband with low loss and large attenuations close in. ?

If these loops were rotatable Q loops like used in the Sinclair Q duplexers, you can do wonders in shape and customization of the pass and reject curves.?

1 - 5 of 5