开云体育

would anyone be able to tell me what brand of duplexer this is??Thanks JohnN4GRW

Thought of what? Inquiring minds want to know why you did not quote enough of the message your are replying to so that you can make sense of your reply. Yahoo does not deliver messages in the order

So I double checked, and I should have thought about this before, but the frequency response looks ok for which side is high and which side is low given the roll off of the 'pass' frequency. So the

The LOW side would be tuned to reject the higher frequency and corresponds to the label IF the notch was tuned to the 467 frequency. The HIGH side would reject the 462 frequency.

You sure the high and low sides didn't get swapped? The labels and the frequencies don't match - high is low, and low is high, in the pic you posted. --- Jeff WN3A

Looking at the photo, I think the sides are reversed. Compare the frequencies to the "High" and "Low" labels. ---In Repeater-Builder@..., <jeremy_georges@...> wrote : Folks, I have

Could the high side and low side be reversed? Maybe it came wrong from China. ---In Repeater-Builder@..., <jeremy_georges@...> wrote : Folks, I have an old eBay Chinese flat pack

I should add that if I increase the split, then things look better (although not great). If I go with a 7Mhz split, I can get the insertion loss down to about 2dB and the VSWR looks good. The only

Folks, I have an old eBay Chinese flat pack that I put on the bench to tune for a temporary use repeater. I can notch it down to 90dB just fine. But the insertion loss is horrible. I'm getting around

Too bad he don't live close to me I have 2 analog eprom rx trays, 3 computer programmable?MSF5000 for sale. Also a MSR2000 vhf base unit complete. To: Repeater-Builder@... Sent:

? Long time on mine as well,but I think it is in the menu for PL or DPL selection in the Frequency/channel area. Just turn off both PL and DPL in the selection line...I think.. ?DWF

Hi James, We have use a Mirage 100W base station amplifier tune down to 60W with fan on the heat sink to keep cool. We had problem at first we the logic part of the Amp when we first bought it

Sent from my Verizon 4G LTE smartphone

Does anyone know where I can get a new phasing harness for my commscope db-224e antenna?? I realize the company has no replacement parts for it.? Thought someone might have one kicking around

Yes, I believe there is.? I think you can select "CSQ", or something similar... but it's been so long since I programmed mine, I seriously can't remember where the selection is. Mark - N9WYS? Sent

Thanks! To: Repeater-Builder@... Sent: Monday, September 17, 2018 10:56 AM Subject: [Repeater-Builder] Re: ID Motorola Channel Elements ? High Band MT500. CAM #yiv3718742387

Thanks - I should have thought of that. Tom

I use TE systems, as Henry has failed me before. Henry also takes some time to actually get them, and power falls off as they warm up. The TE systems desktop amp with a good fan has worked well for

Mike remember a hurricane just went thru there he might be out of powerand don't have a computer connection at this time. To: ! mailing list Repeater-Builder <Repeater-Builder@...>

High Band MT500. CAM