开云体育

Cris. LDG Electronics makes a Voter system. They even offer it in kit form. Their Website has a good description of their unit with a manual in Acrobat Reader format, some 27 pages long. Their

Walter Isaacson wrote: That's odd. I've always used http://www.link-comm.com In any case, not to take anything away from Link Comm, but why not spend 50 bucks on an audio delay board from S*Com?

Thanks. Some 8 years ago or so I was trying to come up with a better squelch/COS board. I breadboarded some circuits but wasn't happy with the results. I sure tried to get my hands on one of those

What Frequencies are you looking for? Ken vo1st@...

Walter Isaacson wrote:

We use TS-32 tone boards on our repeaters. So far we haven't been using CCTCS on our links, just on our drop repeaters. We use 100 Hz encode and decode on our network repeaters. Some of our

I'm Looking for the Programing Code for the RX and TX Frequencies in the Amatuer portion of the "MARCOM V" frequency Range 132-155 any work sheets on frequency formulas, and channel addresses would

Walter, I am in the process of using a Mitrek and an RLC-1. It sounds like your using CSQ on the repeater. Have you tried using the Mitrek PL board with the RLC-1 on any other repeaters? I have

In a message dated 4/21/99 12:11:20 AM !!!First Boot!!!, wb6csh@... writes: << I live in an area next to the Pacific Ocean, and the salty air from that body of salty water causes rapid

In a message dated 4/21/99 11:13:58 AM !!!First Boot!!!, lazer@... writes: << I use it on all my tools, but the stuff is extremely HEAVY. I could imagine that it would double the weight

Hi I am looking for a scan board for a GE s-550 contril head. Or the microprocessor chip for the later version scan board the one without the battery. I think the early verson bord the one with the

Jeff, Do you have a mobile or a base station?? John Lloyd, K7JL Jeff Weinberg W8CQ wrote:

Another option: the rubberized roof coating, applied thinly with a brush to the antenna. It holds up for several years in the Arizona sun. All for now./Comments

I have found that Clear Acrylic works very well. Sold at any hardware store. Rust Oleum, Defi Rust just a few of the brand names. -Dan- Ed Bathgate, RMA Repair Dept x8785 wrote:

Does anyone know of a web site that has a technical description of a voter. No specific brand I just need information on how they work. Thanks, 73 Cris KE4IIF

Has anybody used epoxy paint? I have heard of it being used for plastic/fiberglass dirtbike parts that flex a lot. I have seen it sold in spray cans for kitchen appliance refinishing. What do they

Try the NHRC line of controllers. I am using 4 of them. Total cost, aroun 60 - 70 $!!! http://www.kuggie.co

And increase the wind loading!

I use it on all my tools, but the stuff is extremely HEAVY. I could imagine that it would double the weight of most aluminium antennas! Tedd Doda CET CEO Lazer Audio and Electronics packet