开云体育

Kevin, Yes, the RUS ( Receive Unsquelch Sensor ) is the better one to use. It works with the Channel Guard Decoder ( PL for the Motorola terminology ). It comes out of the Audio Squelch Board on Pin

Hi All, I have a couple of 10GHz gunplexers sitting in my radio room that have not been used for anything, at the moment. I brought them at Dayton a few years ago, and wanted to use them for

HQ54@... wrote:

Patrick Nicholson wrote:

I guess that might have been me, Kevin. I use the RX mute line for the COS signal. Here is my reasoning.... The CAS signal goes high anytime the receiver is active. In other words, if you are

Kevin K. Custer W3KKC wrote: CAS is the 'first' one in line. Carrier Activity Sense. It follows the receiver regardless of CTCSS/CDCSS. J932 pin 18 is one reference I have in my notes. I think that is

To link a few sites you will do i little engineering. 1.) Will the site coverages overlap? 2.) How will the sites be interconnected? ( RF/Phone/Microwave) 3.) How much are you will to spend? If

Hello all, On the GE conversion site I sponsor on rbtip I have information on the conversion of the Mastr II. http://www.kuggie.com/sartech/GEM2/where_to_get_the_signals_from_a_.html A while back

Hi, I will let you know if anyone comes up with a good inexpensive solution! There are several ways to do it, but I am hoping I can find a way to keep everything on one frequency, isntead of going

For all that may be interested (Ohio & surrounding States), I have placed a copy of the April Ohio Area Repeater Council newsletter on my page at: http://www.wa8dbw.ifip.com/Newsletter.html Pass it

Hello, I have a repeater system consisting of a Yaesu VXR5000 UHF repeate and a Computer Automation Technology CAT300 controller. I have the repeater at a church in my city.. The coverage is not that

Looking for a ge master II DC Control Card? anybody that has one for sale or trade please let me know thank you at bug1@... Brent

Hi All, I have several Mitrek VHF radios I would like to convert to repeaters. I have searched the NET, and have found 3 different version of the conversion instructions. I am sure out of

In a message dated 3/23/1999 4:59:54 PM Eastern Standard Time, patrickn@... writes: << Hello, I have a repeater system consisting of a Yaesu VXR5000 UHF repeate and a Computer

if you will contact gene diehl telephone 219 495 5715 he will sell you a complete master II for 45 dollars plus shipping which will have everything you would need to repair yours for a long time. he

i have a motorola commander series model L1474A remote consel and would like to hook it up to my GE master II low band Base can any body out there help ? and in what refrence would the control

I have done maratrac's with the m 400 software and no special keystrokes were required to take them into the ham bands just direct entry. tom n8ies Jim Horvat wrote:

Are the Red/Black wires still connected to the TX relay at the antenna connector? They should be cut. mch wrote:

Then Joe Orrico WB6HRO wrote: But how would a receiver connected to an IFR differ in voltage from a receiver connected to a duplexer? In case I gave the wrong impression, the unit is still at the

There are jumper changes when you install/uninstall a CTCSS board. I know one is on the front/left side of the system board (with the handle facing you). That is the PTT control jumper that selects