开云体育

If AllStar is all you want to accomplish, you could just set up an AllStar node and set it to TX on your repeater's receive frequency and RX on your repeater's transmit frequency, just like how you

Friends, I have a Quantar that has VHF R2 modules.? I would like to try a VHF R1 Module in it.? Seems unlikely, but is it as simple as powering down and swapping the modules? Thanks! Jeff KC8VFN

An acquaintance has a few GM300s as control receivers on his repeaters (MTR and Quantar). He used to haul around a Toughbook for radio programming and a Toshiba laptop that booted into MS-DOS just for

Pinari, I'm going back decades here, but this is what I remember: As others have pointed out, the R100 repeater is based on European mobiles that have much in common with (but are not identical to)

Or you can buy the Northcomm plug in controller and select up to 15 channels remotely via DTMF.

Wire a 16ch BCD switch to inputs 1 through 4 on the 50 pin and I forget if the switch grounds them or if you pull them high but I can check if needed. Then you need some wildcard instructions to tell

Channel selection on my MSF5000 station is easily accomplished from the from panel, but that does not seem to be the case on a Quantar.? How is it done? Thanks! Jeff KC8VFN

Hi Chris, I was thinking about buying one, but it isn't' clear to me now that there would any value added for a VHF station (which is all I have).? It seems like the Quantar instructions manual I

Have you tried some of the local ham radio swap meets? There is often lengths of LDF4-50A with connectors for sale cheap.

Did you save the original codeplug? If so, I would start with reloading that. [email protected]> wrote:

The boards are from the German made MC Micro series. They are, in fact, mobile radios repurposed to be a repeater, whether you’ve seen one, or not. I hope that helps, Will

Are you selling??? [email protected]> wrote:

I've been very satisfied in my dealings with Davis RF. https://www.davisrf.com/ Dan, W1CDT

Sadly, WA1MIK is a silent key so I doubt the “make-cp” program is available. The data in the eeproms on the R100 is very, very susceptible to being corrupted if using too fast of a DOS

Hi. I have examined the radio and it appears that the original (codeplug) eeprom has reached the end of its life and needs to be replaced with a 24C01 or 24C02 serial eeprom chip. WA1MIK has made a

Hi, As I continue the work on my local VHF repeater, I'm looking for some hardline for a 50' run. Right now, I'm looking at LDF4-50A from ABR. Does anyone have any experience with them or have any

900 Quantars require one (though Mike's correct, a generic GPSDO is cheaper and achieves the same thing)

Actually, I've veen running an R100 repeater as an Allstar node continuously for over 15 years...of course, it's turned down to less than 1w and I disabled the internal PS a decade ago. Also, it's a

Sorry, I haven't assigned one yet.

So after the fiasco with the blue mad cable which never worked for me btw, had a chance to program the mtr2000. It’s an uhf station 40 watt and it was originally all green when I first got it. Read