开云体育

I THINK It was sold under Prodelin but Celwave was also a seller....the connector is Hex shaped on the outside....the one I have is male N but a barrel is pretty tight on it making it a female N

Excellent idea.? I will dig out my probe and MSF 5000 Preselector tuning instructions today.? Thanks!

UUUHHHHH NO...If you look at the center pin, it has THREADS on it....hard to screw that into solid center conductor..... [email protected]> wrote:

7/8 inch with solid center conductor is likely Celwave cable, not Andrew....I never have seen Andrew with solid center.....I guess its possible but the Celwave stuff Ive used is solid and looks like

This is just a thought. I had old sp50’s and if you don’t know they don’t like to move very well. I did the hex edit in those to cover 0.00 to 999 mainly to use on 2 meters but say I got a uhf

It’s a shame I got a small 4 foot ge cabinet but in South Carolina

The helical casting does have the holes to insert the white probe cable that the MSF5000 uses and the instruction manual does come with that cable if you ordered it. It's more or less the same

Subject: Andrew

Nope...that center pin screws into the center conductor. The type I need would SOLDER onto the center from what I see. But, thanks. - Mike Sent: Friday, March 14, 2025 9:57 PM To:

I am currently configured for the alternative method DCFLuX mentioned below using the tracking generator feature.? I tune the duplexer notches in the same manner.? I was wondering if there is a

https://www.ebay.com/itm/235952762386?_skw=ldf5-50+l5pnf&itmmeta=01JPBR8DKM2 GF8PJ72GPT0ZN3P&hash=item36efe16e12:g:JJ0AAOSwNC9nqmhI&itmprp=enc%3AAQAKAAAA 8FkggFvd1GGDu0w3yXCmi1cPb1%2FxT%2Fs%2FM7Z2JcX1

Hello Chris, It is VHF 150-174 MHz. Thanks! Jeff

I have a length of the older SOLID CENTER CONDUCTOR 7/8" hardline and need one connector. I am not particular about the gender but an "N" female would be most useful. If one is available please

Easiest thing to do is set up one of your service monitors as a signal generator on your desired frequency. I prefer to use the Duplex Out into the receiver antenna jack on the back. From the RX

VHF or UHF? I just inject a signal and tune for best Sinad sensitivity in the speaker.. Chris WB5ITT [email protected]> wrote:

Circulator, which is a passive element allowing the passing of RF signals only in one direction, is a key element in almost any RF circuit technology. An isolator is based on a circulator, having a

Friends, I need to retune the subject preselector and was wondering if there are any procedures someone could share or point me to.? I have a HP8320B and a HP8935 to do the work with, but I could

Hi everyone, I have a large, unable to be shipped, approximately 7 foot tall open rack with 19 inch rack rails that I'm thinking about selling. Would like something a little bit smaller and enclosed

* Circulators are used all the time in LMR...Combiners have them, I've used them on conventional systems where IMD was a problem...never called them isolators in my 50+ years of LMR.. A circulator

Circulators are used all the time in LMR...Combiners have them, I've used them on conventional systems where IMD was a problem...never called them isolators in my 50+ years of LMR.. Chris