开云体育

Bomar?? Oh hell no....poor quality...I threw anything from them away...

If you have a lot of patience, and a lot of channel elements, I have had good success with just swapping the Xtal into an element that has good stability across the temperature range (~10f to 100f) I

Hi Karl, Have you tried?Bomar Crystal Company?? ? http://bomarcrystal.com/index.html ? 117 William Street PO Box 10 Middlesex, NJ 08846? + 1 (732) 356-7787 + 1 (800) 526-3935 FAX: + 1 (732)

I have a project with a voting system and wondered if there is a cheap way of transmitting this 2175Hz tone from a remote site? was gonna do microwave, but thats too expensive no internet at this

RF Technology IPPA150Q 180 watt continuous duty VHF (136-174 MHz) repeater amplifier. 1-3 watts in adjustable output to 180 watts. Built in 45 Amp power supply. 120VAC input, 19" 2RU rack mount.

I built this for two repeaters that share a single antenna 444.5TX, 444.7TX and 449.5 RX and 449.7 RX. I used 2 8” BP cavities on each TX with a two stage isolator and 3 4” BP cavities for the RX

Hey, you're talking about some of my best work! You forgot to mention lots of clip leads. (I was once chastised by WB8MCS who told me, "No clip leads on the repeater!" That was back with tube

JLPCB offers small-batch boards and SMD installation at pretty reasonable prices these days. I wish it was a US company but until someone in the US starts up a similar business that is what we are

Tom, A picture is worth a thousand words. Do you have one you feel comfortable sharing? 73 and aloha, Eric KH6CQ

Jeff, Those perf-boards and? a PL decoder here and a PL decoder there get away from you. I am rebuilding the Holland (Mi) repeater systems. New cabinet and some nice Quantars and MTR-2000's. A Doug

Karl, I think you dial it just like it is on the website. 31 is their country code. Gerald wd0fyf

I see what you're saying as well. I guess if I know I'm going to be the only one to ever use X device again, I have no problem modifying it to suit my needs. I mean, hell, we're talking about voters

KLOVE has always been the actual maker of the Quartslab crystals....Quartslab was merely the front end seller....With Quartslab shut down (again), KLOVE decided to sell direct. Same quality as ICM

Yea, thanks Doug; it did try them but the phone call would not go through. I believe the international code is " 01 " but no good.? It used to work when I was with Kaelus talking to co workers in

Karl, Correct. Those are the GE comparators. These are the newer units that are black in color and have updated cards with LEDs on them. The older units are gray in color and have cards with

So, this is what the guys are talking about for GE?? This is on ebay. I guess I did not remember the two "version" the older, gray one (which I'm somewhat been around) and the newer(?) dark one?

Maybe in a tube repeater, LOL. Seriously, there's simple ways of not to use a relay or any mechanicle devices.? When I ran the RVS-8 I bypass the relay in that, too. But I understand where you are

Karl, Try KLOVE (https://www.klove.nl <https://www.klove.nl/>). ex Quarzlab. Doug - GM7SVK

Boards are easy to make…what about the software? Sent: Friday, November 18, 2022 12:34 PM To: [email protected] Subject: Re: [repeater-builder] FS LDG voter RVS-8 Lots of SMDs on the (OEM)