开云体育

/g/Ham-Antennas Might be of interest to you. Joe, K1ike

You should stop counting to four, Don. >:-} 73, Gary - W6GVS

Thanks, Jim -- - Regards, Karl Shoemaker To contact me, please visit SRG's web site at http://www.srgclub.org for the current email address.

Karl Go to [email protected] and subscribe. You can ask questions there. Discussions of all things antennas. Mostly HF but all bands are welcome. 73, Jim W7RY -- Thanks and 73, Jim W7RY

ok, sounds good. Normally gov, commercial or whatever just procure equipment and install it. I think only the amateurs do mods.? I'll check back another day. I have the Raytheon one and it works

Don, That sounds like it is going into PA rollback and reducing power.? Check your status panel and logs in WinRSS to see what those say when it is doing that.? If you have high VSWR in normal

I don't know but I'll check it...I bought it a while back and the guy said it was pulled from service ..but didn't get into the details

Been following this Topic , I will try this on My UHF I adjust it and it Keys up 98 Watts into Bird wattmeter and Bird Dummy load …Then If I count to 4 It drops to 48 watts .. I took it of the Air

Anyone know of a group that might like a discussion about HF baluns??? I'm doing some research on brands and types (current vers voltage) and core vers air, etc. This would be other than the SDX

Calibrate it for the actual rated power then turn the power down in the channel settings. Intentionally calibrating the station inaccurately is just a horrible idea. A 125W station can be turned down

Chris, has it been modified to work without a ST?? (status tone) -- - Regards, Karl Shoemaker To contact me, please visit SRG's web site at http://www.srgclub.org for the current email address.

It appears that I need to add a little information to my notes as to how I make Occupied Bandwidth measurements. For analog systems, all measurements are made relative to the amplitude of the

It appears that I need to add a little information to my notes as to how I make Occupied Bandwidth measurements. For analog systems, all measurements are made relative to the amplitude of the

Thank you for all the info JB. We have many Micor still in service and we rarely have this problem with them. Compared to the MSR2000. I was thinking the difference is the Micor female pin is all

In the RSS , The power out which is showing on the watt meter and then click adjust. The software will automatically turn the power up or down and try to correct it to 125 watts out. However I usually

One more look at D-Str - as Burt said, a chart without numbers is just a pretty picture. In their literature, Icom said: "D-Star channel spacing = more repeaters"? AND "Requiring only a 6 kHz

Our club just bought one. Try contacting them. Les KeeganN4LPK

im looking at doing the tx power alignment in the quantar i assume a simple rf meter and dummy load is needed to align this.. if i remember correctly the alignment instructions simply say if the rf

Here is the attachment.

Any Motorola Quantar Wild-card Programming Experts out there? I have a Quantar T5365A that I need to interface to a RL Club controller. The issue is I need to bring out the COR signal and PL Valid on