开云体育

Yikes!!? This tells me you need to read up on calibrations first.? If "someone said" it was 1kc low, then you can't trust anything.? Period. You have a R1200?? Like 50 years old?? I would be

Anyone know if pin 5 on the rear DB-15 connector on the TK-7302 is just "external mic" input with associated filtering/pre-emphasis and good for only 1200 baud packet, or if it can also be set to

done GeorgeC W2DB

And the signal generator output is accurate? Get someone with a more current and calibrated unit to verify. *Seems to me you are using an R1200 service monitor that is 50+ years old?* 73, Jim W7RY

Hello everyone, Once a year I ask for financial support to help defray the costs associated with the upkeep and furtherance of free repeater related help sites.? Repeater Builder continues to grow as

This any help Mike? https://www.hirensbootcd.org/old-versions/ John - Down Under

Mike: I may have misunderstood your request but here is a possible solution. I have not read through all of the emails, but of those that I have read, I have not seen a mention of "Casper" (Get

This was replying to Alan (or who cares) because I can't figure out what switch needs to be thrown to make the quote feature do what I want.? If only there was a referrence and a spell checker...

Unfortunately, detailed explanations of how this was done have been purged from forums and groups along with any valid license keys because usoft sifts through the internet to kill any mention. If you

It certainly is worth getting the receiver back to where it belongs. I’m not going to take the time and drive to the site and install everything just for it to continue to be deaf and run like

Are we sure the receiver (and/or the service monitor) is on-frequency? Mike WM4B

I have to agree with Chris on this.? Running raw discriminator audio directly into the modulator is going to cause problems.? You need "something" ahead of the modulator to control the maximum

1 dB less than that is typically what I get out of a MASTR II or MVP, which has the same spec. However, at least here in SoCal that's pretty much equal to the noise floor on 2 meters. Depending on the

Spec for the MTR2000 VHF is 0.35 uv or -116 dbm at 12db SINAD, so his receiver is pretty close. Brian n1bs

Okay - - Yea - -115dBm for 12 dB SINAD is pretty numb. Many receivers are much better at -120 (something) or so for 12dB SINAD.

IDE drive device ID/order is determined by the controller (typically only one is present). SATA drive device ID/order is determined by which SATA port/cable a drive is connected to. The BIOS has no

The MTR is reading 0.4uV (115 dBm) at 12DB SINAD. I’ve aligned the repeater 3 times now and even tried directly to the port on the receiver module. I must be doing something wrong, my UHF MTRs are

Can you give me some more details on how to make these measurements? Brandon Vetter Office 208-714-4651 Cell 208-625-0892 www.Inter-Wave.net<http://www.inter-wave.net/>

Brandon Vetter Office 208-714-4651 Cell 208-625-0892 www.Inter-Wave.net<http://www.inter-wave.net/> [cid:image001.png@...] Sent: Wednesday, November 2, 2022 6:09 AM To:

I may have missed something but have you tried this ? Hook a transceiver to the antenna and see what kind of range you are getting.? If as expected, hook the repeater receiver input directly to the