开云体育

All my repeaters , regardless of using flat or non flat audio sound like simplex...I'm a sticker when it comes to audio...too many years in broadcast engineering I guess lol...it's not hard to do

Have a blessed day/n4jem

I recommend this instrument or equivalent as a very accurate and revealing way to test and set up your repeater audio performance. I suggest you first set the repeater up according to the manufactures

" until you become familiar and ultimately used to better audio - you don't want to go back to industry standard. " Amen to that. This is also why some people actually think that YSF or other digital

Dan, I'm glad you realize that you are going off far into the weeds. I don't disagree that many stock repeaters have "industry standard" frequency response - but for some of us - we want more. This is

How? I have started the software in dealer mode, but dont see anywhere to change it….is it possible to do a hard reset on the repeater?

You must not have a tongue or teeth; my sympathies. "Bass boosting"? No one has mentioned that; what does that have to do with this discussion? Why not? Why? I'm sorry but this is borderline nonsense.

Here is some additional good reading on the subject of FM Transmitter frequency response and some reasons it is limited in most FM transmitters - from Repeater-Builder no less:

Kevin, Thank you for your comments.? I agree on all points 100%.? One thing you said that is especially true that I also tried to get across earlier... I can also hear the difference between a

Kevin, I do agree with you that this group can be about going outside of what is normally done with repeaters and improving on them - so in that respect maybe my comment was a bit off the mark. I will

But that's one of the reasons this group exists - not most of the other things you wrote about.? Keep that in mind when replying to this group.? We're about highly technical stuff here. And - just

Just a note from the gallery here - but to me it seems that some are confusing frequency deviation and frequency response in this thread. Both are important for their own reasons, both are measured in

Was there supposed to be an image in your reply? I just see a blank box. 73 and aloha, Eric KH6CQ

Can be changed it you have dealer software Have a blessed day/n4jem

We have multiple vxr-7000 repeaters in use, and I kludged one up. I suspect I did a download, rather than an upload, and installed a config file, including the serial number from a second repeater. Is

When I got started the high notch was out of tune. I went back and put it back to original frequencies and got -69 and -65db notches. On the new frequencies it is -62db you are probably right about

Yes, Burt, I also agree with that concept because it is better in those circumstances of low initial audio and to me it also makes sense to increase intelligibility when you are receiving noise on the

Mt Wilson's rep lasts a long time! -------------------------------

jb, I want to assure you that WA6TDD was not that way when I ran it.? Once it started to turn in that direction I tried my best to clean it up.? When that failed I took it off the air and others