开云体育

Thanks to all, I ordered a few from here last night. https://www.ebay.com/itm/124991949863 I'll see what comes in the mail. 73, Joe, K1ike

The Kenwood accessory connector doesn't use .093" pins - they use .062". Bob NO6B

I have said connector in front of me. I think most TKR/NXRs already have it as it contains a jumper to connect the front panel speaker to the radio. The pins are .062 size & 0.145" pitch.

The original Molex part number 03092158 has been replaced with 03092159. The Molex .093 male crimp pins for 18-22 gauge wires is the 1380 series. I have gotten the housings and pins from Digikey. Joe

They are available on Ebay. I got one from there with the cable. Just do a search foe KENWOOD TKR repeaters and they will come up. Les KeeganN4LPK

The general transmit audio input (+ and -) on the 50 pin telco connector. You may need to set the station to simulcast to get this input active? Thanks, 73, Jim W7RY

My first thought would be to try and read and write a M1225. If you can read that, then you know your programming cable/USB setup works with that software. Another down and dirty R1225 interface for

Hi there, My eBay misadventures left me with a set of five Motorola R1225 repeaters, from the estate sale of someone who either ran a radio shop or bought a ton of stuff from one. All five had the

Steve, I use Petroleum Distillates, which is used in many different things, such as carburetor cleaner, etc.? Just soak a rag or paper towel.? That will also get the remains off of you hands. 73,

Thanks Ken, I was afraid of that. I'll contact my Kenwood dealer and see if I can source a few of them. Joe

Uh duh...... Yea, Molex discontinued the 15 pin but the KW part # is E37-0913-05 (connector and cable)

If you read his email, I believe he is looking for a part number for the connector so he can purchase one.? "information for ordering" Mick - W7CAT

As a Kenwood Dealer, I kinda felt like Benedict Arnold installing a Quantar for my 2 mtr repeater but I did and it works great with (of course) an RC210. (using the Telco connector and it has the

Here ya go Ken ------------------------------------------------------------------------------ President and CTO - Arcom Controllers Makers of repeater controllers and accessories Phone: (503) 678 6182

Goo-gone usually works for me but sometimes you have to get something stronger.. All depends on how long it's been there and sitting out in the sun drying Chris WB5ITT

IIRC the 50pin Telco connector has a flat RX and TX connections that should meet your needs . Just about everything is available on that connector. I've had problems interfacing a Quantar to an

Would anyone have handy the information for ordering the 15 pin molex plug on the back of these repeaters? It's labeled TEST/SPKR and is the ACC15P plug. Thanks, Joe, K1ike

I use ACETONE on a rag…works good for me. - Mike Sent: Sunday, October 23, 2022 7:23 PM To: [email protected] Subject: [repeater-builder] antenna connectors Is there anything i can use to

Is there anything i can use to remove the sticky mastick tape off connectors the previous installer did not wrap with scotch 33 or 88 ? Steve Flory W9KOP sflory@... "I like climbing towers

Greetings Gang, I have a question for those QUANTAR Gurus in the group. I need to feed wide band analog audio - from 50 Hz to 6 kHz into the transmitter modulator.? I've found a place just ahead of