开云体育

That's correct, Joe. Same formulas & general parameters. -W6XC

Sorry Rodney, I was looking at my NHRC-3 M2 manual -- This email has been checked for viruses by Avast antivirus software. https://www.avast.com/antivirus

I have some old GE MASTRII training documents and thought that it had the information contained in it, but no. I think the MASTRII and MVP shared the same crystals, just the oscillator holders were

Have you tried setting the first character of the ID to FF (end of id) Gerald WD0FYF -- This email has been checked for viruses by Avast antivirus software. https://www.avast.com/antivirus

Hi folks, I recently purchased this meter off of Amazon and it appears to be a good one for $50 OTD.? Well at least, as long as China stuff does.? I've made my measurements in load center and I'm

I'm selling because 33cm in the metroplex is a mess. to much part 95 QRM.

927.025 150w to the duplexer

Looks scary to me. -- Regards, Karl Shoemaker To contact me, please visit SRG's web site at http://www.srgclub.org for the current email address. -

Mark, Not to be a smart-alect, but you could hold this device at the focal point of a FAA radar or height finder, then deduce about 30 dB of intensity for cell towers.? But getting them to let you do

Clif, No thoughts on the value, but it looks like a BpBr type, similar to the Wacom brand.? If you have a way to check it out prior that would be best. If the bottom of the cans can be open then in

Eric, I may have some for UHF. Give me a shout on the email listed on my web site (below) -- Regards, Karl Shoemaker To contact me, please visit SRG's web site at http://www.srgclub.org for the

Tony, I have to agree with what you said, That's what shyed me away from QL.? The vendor in CA, USA, I've been using has been good and they come up with the parameters. -- Regards, Karl Shoemaker To

I'm wanting to say 27-30pF, Bob. -XC

Would anyone know where I could find or have made a pair of compensated channel elements for a 440 mitrek for 446.860- or 446.88- (scrrba test pair) or possibly 440.500 or 440.550 (test pair in

I have a Master II with a NHRC-4 M2 controller. We are looking for information on shutting off the CW ID. We have not been able to find the information in the Manual to shut it off. Any help would be

UHF TX. I already know the multiplication formulas (TX = X36, RX = X27 - 11.2). I just need to know the loading capacitance. W.r.t. QuartSLab: if necessary I may have to place the order, but only

If an xtal company has to ask, I would go with Quartslab. At least they have the parameters. Otherwise, you may have to go with them anyway. Save yourself the time and frustration. I'm getting ready

I'm looking at a set (not physically yet) for VHF. They are in a cabinet which has seen better days but the cavities look good. He said they are 6" in diameter (4 ea) and they have a tuning stub

What band MVP?? It may make a difference.? Receive or transmit?

I think there is some confusion here. The Rad Block meter measures Electro Magnetic (EM) fields, not ionizing radiation like a Geiger Mueller tube. However, my wife was trying to find an ionizing