开云体育

The is a diagram using motorola T1500 duplexers for this exact case, and you can try searching for it. Basically it takes 3 sets of 1500's each repeater has a duplexer that is then fed into a third

The big unknown in your case for how big a battery is how long does it take for you to respond if a total power fail occurs. You have to figure the powerloss as time zero, add noticing loss if not

Details!? ?Where is it available?? How much?? ?What does it do that the thin client doesn't?? ?? Vendor website info would be handy.?? ThanksChuck? ?n0nhj

Everybody keeps talking about mods to the GE voter. E&M signalling is standard on them, even the old grey ones. So voter tone isn't needed if you have a relay closure or other good switching.

Our repeaters are all under a single radio club and everyone is a team player, so I don't anticipate any political issues.? I was nervous about sharing a single power system among multiple repeaters,

You may need to look at a board house that will stuff the majority of the parts on the board. Depending on qty of boards that may help price point. Stan

I have to sit down and figure out the per unit price, but I probably won't be able to compete with the price point once labor is factored in.

All, Upon further review, I overreacted to this situation. I had a awful day full of stress and I publicly apologize to Terry for my overreaction. Scott -- Scott Zimmerman Amateur Radio Call N3XCC 474

All, As group owner - I asked Terry to send me the photos - which he did immediately.? After reviewing them - I don't feel that Terry did anything wrong - - and I don't feel he misrepresent the sale.

If there were an old Moto/GE lowband or hiband radio that would run on 6 Volts and was nearby me..... I have a 1957 Jeep FC-170 that is still 6 volts and a vintage radio would go well in it. :-) Eric

WHAT? Its GONE!!! Jim W7RY -- Thanks and 73, Jim W7RY

Voter has been spoken for Thanks Scott

Joe, just as I mentioned in the previous post, it was all off of one DB420. I teed off the feed line with the six can rackmount notch duplexer. I'm trying to remember exactly how I had it tuned but I

Any idea on the price, Matt? The current price of the RTCM is expensive for several sites, even with $100 off for the ham price.. like most hams I try to be cheap ? Chris WB5ITT

Actually, Frank is there any old Moto stuff that you would like to have?? I finally tossed my 5-pipe sensicon receiver that I used for the repeater in 1974 ! -- - Regards, Karl Shoemaker To contact

Sure, Frank, it might be fun to play with as I have not seeing this model.? Please run over to the web site and send me your email or number. There's enough amateurs going to Spokane that could bring

Scott, I have two of them and wrote a supplement manual post on the web site for the next owner. -- - Regards, Karl Shoemaker To contact me, please visit SRG's web site at http://www.srgclub.org for

Bought this from a trusted friend a few years ago… I had big ideas for this but never got around to doing anything with it I dont think it has ever been used! I would like $220.00 for it shipped to

So, now that we have progressed from occupied bandwidth to SPD and on to ACPR, we have identified the test method that will give us a true indication of how good a neighbor a system is. Anyone who

Is this going to be offered as a product or kit? -- The Real RFI-EMI-