开云体育

Yes they will. Any CTCSS encoder/decoder should work as long as (one way or another), it provides full duplex operation Ken

Hello Ken, If it comes down to it will the boards work with your cable setup and board you supply? ?? I understand it takes special software and it can be costly to get the software but as time goes

Another issue with the Midian boards is they're not field programmable as it takes a special programmer to do so. (we looked at Midian but obviously decided they're not what is needed) Ken

Interestingly, the schematic shows RA/RD with a spec of 80mv and 400mv respectively. It also shows an TA and TD pins. Those are Kenwood's nomenclature for RA = De-emphasized audio RD = Raw

Hello Jamie, Has your club found a buyer for the controller??? I would be interested in talking with you about it. Thanks! Steven H N8RLW

Has anyone taken the Arcom plug and play PL board that gets used with the Yaseu repeaters and wired in the Midian TDS-5 pl board? ?? It is my understand it takes a total of two Midian PL boards one

I'm in need of 2 to 3 of the ComSpec SS-64 tone boards. ?? Does anyone have new or used that is known to be working.??? If so please message me directly through the board. Thanks! Steven H. N8RLW

Hello Group, 1.? I'm looking for the manual for the cat 1000 as the old repeater tech no longer can find his copy.??? Is there a online PDF out on the internet to be able download? 2. Does any one

I need to check the service manual but logic would dictate there has to be some point(s) where one could tap the signals required Ken

Who knows. These are something I don't care to get involved with, so I'm probably just going to sell them. They belong to a non-profit I am involved with, and we don't use UHF anyway. I was told if we

"If you are building the cable for the repeater it is easy to build the serial cable." If is not a serial cable going the repeater. Mick - W7CAT

Hello, Does anyone know the tuning procedure for this unit? I am unsure about the 3 tuning controls on the connection side. Thanks. Tony, W2KJV

contact me off line if interested

how much you asking? for the MTR3000? ? ka2caf

Any one interested in a 100 watt UHF MTR 3000 before it goes to flea bay I can be reached at dshack at rogers dot com

Since CATAUTO is no more, ask around and software is available. The cable is serial. If you are building the cable for the repeater it is easy to build the serial cable. Read the manual on

If done right these are pretty useful systems. Lots of radio (commercial) like your CDM are easily interfaced. Some used BCD logic to channel steer or control the radio. Each function is mapped to a

Hi Matt, At the dispatcher end, there's a "tone remote" that typically encodes a 2175 Hz high level guard tone, followed by one of several function tones, followed by 2175 Hz at a lower level for the

I've built several 2 M. Z-matchers, using either piston or APC air variable caps around 30 pf maximum, and a coil of 3 turns of Nr 22 wire, 1/4" i.d.? These 3 components are wired in a Pi

Hi smart folks, I’ve read a fair bit on the site and on the Internet at large about how tone remote stuff works. I think I understand the theory fairly well. What I’m less clear on is how people