开云体育

"If you are building the cable for the repeater it is easy to build the serial cable." If is not a serial cable going the repeater. Mick - W7CAT

Hello, Does anyone know the tuning procedure for this unit? I am unsure about the 3 tuning controls on the connection side. Thanks. Tony, W2KJV

contact me off line if interested

how much you asking? for the MTR3000? ? ka2caf

Any one interested in a 100 watt UHF MTR 3000 before it goes to flea bay I can be reached at dshack at rogers dot com

Since CATAUTO is no more, ask around and software is available. The cable is serial. If you are building the cable for the repeater it is easy to build the serial cable. Read the manual on

If done right these are pretty useful systems. Lots of radio (commercial) like your CDM are easily interfaced. Some used BCD logic to channel steer or control the radio. Each function is mapped to a

Hi Matt, At the dispatcher end, there's a "tone remote" that typically encodes a 2175 Hz high level guard tone, followed by one of several function tones, followed by 2175 Hz at a lower level for the

I've built several 2 M. Z-matchers, using either piston or APC air variable caps around 30 pf maximum, and a coil of 3 turns of Nr 22 wire, 1/4" i.d.? These 3 components are wired in a Pi

Hi smart folks, I’ve read a fair bit on the site and on the Internet at large about how tone remote stuff works. I think I understand the theory fairly well. What I’m less clear on is how people

For the MASTR II VHF PA? If so, our Z matcher has air variables on it. Jim W7RY -- Thanks and 73, Jim W7RY

I am not currently in a position to part with them, but in case a close-up photo is helpful, please see attached. It is my understanding from the Repeater Builder page that they’re 0.1” spaced.

anyone have one to share? What value for the piston trimmers for the 2 meter band?

we bought the cable, but dont believe it works.....and I think we are going to keep the software for now.

Do you have the cable and the software

Is the audio available on the control board, just not brought out to the accessory connector? Bob NO6B

Band Reject only. See the attached doc. 73, Joe, K1ike

Thanks all. I'm trying to source or buils an original cable set. I have a chassis and housing, just missing the cables. Trying to make a complete repeater. Jeremy

No difference as far as interfacing to an external controller. The question was regarding a TKR-D710/D810, which is a DMR/Analog repeater. The NXR-710/810 are NextEdge/Analog repeaters. Kenwood made

They should swoop in and tax all those garage sales around me. Some folks make a living by it it seems. Meanwhile Jeff Bozo can write off his rocket hobby. -- The Real RFI-EMI-GUY