开云体育

I like to use the curved or straight pick from the Harbor Freight pick set, depending on which one I grab. If the SCM card is being stubborn I've had it bend the tool on the back of the front

The cover plate is a board puller, FYI. There's a metal tab on the backside of the board cover faceplate (the one with the Speaker).? If you turn it around, you can slip it in to a groove at the

That's strange, I often get better coverage than it gives, and rarely (I don't remember a case) don't get it where it says. Make sure *both* antennas are entered correctly (it defaults to mobile

I have found Radio Mobile to be quite accurate. As I recall, there are certain parameters that need to be set in order to get that accuracy. Haven't used it in years, however. It did compare well to

Hi, Radio Mobile is a toy... Send me the coordinates and tx, antenna, cables etc parameters and I will try a real coverage simulation with the ATDI's ICS Telecom professional tool. I think there are

This evening, once again, I tried Radio Mobile. I tried it a few years ago at the request of the frequency coordinator in eastern Idaho. And again this evening with similar results. If only I had the

To the best of my knowledge, the 751/851 production was close in alignment to the 750/850 version 2. I'll defer to others here who own/operate/run Kenwood shops. Jeremy K1LFK [email protected]>

Anyone have need for a TxRx Model 89-96-90210 (that last part cracks me up) Preselector for 929-932? Pics

Thanks, Jeremy that's good to know. I mentioned it to my radio guy. He didn't know much about the 851, so maybe that shop to deal with many of those. Do you know how oldthose radios are approximately?

With the TKR-851 being designed for 1-25w operation, that's probably your best candidate for this application. I have two of them set aside here for future projects that require an external

Should've mentioned this in the message, but I have the 850 version two, and a TKR 851. Chad Nelson WI9HF/WRPL979 Janesville Wisconsin 608-754-8671 Send from my spectrum iPhone 16.

Chad, If your TKR-850 is a Version 2 radio, the output should be stable at 5 watts in the low power setting. I have ran them as low as 1 watt and never had a problem. The early radios prior to the

Bypass the pre driver board...the driver board is 8 to 15watts input....that's the PA6-1BE model Chris WB5ITT [email protected]> wrote:

Might be safer to throw an attenuator in line.

Consider this is a test of our resolve by those who stand to gain financial gain from the selling of the spectrum. They will infringe on the known spectrum of radio amateurs to see how many squawk

Hi all, I have the TPL PA6-1AE UHF repeater amp in stock here. Curious if anyone knows if the imput drive can be adjusted to support 10W drive instead of 5W? A radio tech looked at it and said

I consider this a National Threat because it started in Los Angeles where it’s cause great interference to the 222-225MHz spectrum and is now moving to Southwestern Arizona. Please remember Amateur

We better not lose it

+1 to that. You know, the ARRL isn't the end-all, be-all of amateur radio. No reason that a well-meaning group couldn't start another national association and weed out the corporate

Uh, what? You've got a bent up chassis then. I've never had issues like that and I've worked on hundreds of the things. The SCM and WL cards can be a bit of a pain but still don't require that level