开云体育

[email protected]> wrote: Ack! Not me! I have a day job :) Do you know what the power supply current requirements would be for the synthesizer, LCD and Arduino? I still marvel at my SW40+ that uses

Sold.

thank you

I can see where Jim would rather not have us copy his gerbers, Hundreds of folks will know that he did the design, and a few will inevitably pester him for help. If stealing a significant part of the

Chuck, I think we all agree that your design will be plenty stable. It is crystal controlled, going from zero to 12v on the bias for the varactor that is in parallel with the crystal can only move the

Agreed Mike.? Good to hear from you again.? Jim just doesn't want a mass distribution.? Note that he encourages builders to make their "OWN PCB".? I agree that it was an amazing design.? Jim is

Rob there is no problem with anyone making their own board for their own use, it is the distribution of those boards that is the thing that I object to.? Jim does not want to not does he have the

The use of ADE-1 (or SBL-1) diode ring mixers make it possible for the receiver to have a very large dynamic range.? It also makes it possible for the receiver to suck down the battery much more

Nick, I've made some measurements using the?SA612?oscillator in my WWV +?30m receiver. The crystal is a single, 10 MHz nominal.? Keep in mind that this is a simple DC receiver and may not meet the

Rob -- If you have a copy of "Experimental Methods of RF Design", take a look at chapter 2 "Amplifier Design Basics", first few pages, which discusses simplified models of semiconductor devices. I

Doug, From Jim's email on November 10th: Finally, all of the documentation for the 2N2/XX is on my web site: www.k8iqy.com ( http://www.k8iqy.com ) so you can get the docs, build any of the 3 bands

OK..no problem. My point of view was that it is a well documented hands on DIY project transceiver worthy of hand crafting for yourself..... not any money making ventures.... and since I learned how

Rob, the 2N22 is the intellectual property of Jim Kortge.? He has asked that it not be made available.? Please honor his wishes and stop promoting this project.? It would be wrong for anyone to

NO WAY The project is only dead if you want to leave it resting. All of the wealth of documentation is there to make the 2n2xx tranceiver on ANY base you want... island pads... manhatten ... or PRINT

The designer has voiced he does not want to offer a board.? The project is dead. Lee, w0vt

i would like (at least) one jerry aa1of franconia nh

Steve, if the Chinese wanted to copy it, they would do it gerbers or no. If I were the designer, I would be more concerned about having to support the builders if I produced new boards. One way around

I cut my gums on 741's and 2222's.? Put down for a couple.? Thanks, Howard, n3fel

You can look back through the message subject for the details. The designer of the 2N2-XX chose not to release the Gerber file for the PCB. Frankly, I wholeheartedly stand behind his decision.

What's the status of this? I would be interested in this as well.