¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io
  1. Qlog
  2. Topics

TCI error when you change Rig!

 

If I use my HF-Rig and it run TCI-protocol, and if I am on 18mhz and change to my QO-100 rig, in the maneger, then Qlog send the TCI command
(The QO-100 rig use Hamlib via serial.)
?
?
> vfo:0,0,61440000;
> if:0,0,0;
> dds:0,8089500000;
> tune_drive:0,50;
> drive:0,50;
> tx_enable:0,true;
< VFO:0,0,8089500000;
?
the HF-Rig is now on 61mhz ??? and also my QO-100 rig
?
I can only get the correct RX/TX frequensy if I disable/enable the Rig?
?
using qlog 0.40
?
73" OZ1CT Ben?
?
?
 

Is this a new behavior, or have you seen it in previous versions?

ne 24. 11. 2024 v?14:15 odes¨ªlatel Bent Andersen via <eskolin=[email protected]> napsal:

If I use my HF-Rig and it run TCI-protocol, and if I am on 18mhz and change to my QO-100 rig, in the maneger, then Qlog send the TCI command
(The QO-100 rig use Hamlib via serial.)
?
?
> vfo:0,0,61440000;
> if:0,0,0;
> dds:0,8089500000;
> tune_drive:0,50;
> drive:0,50;
> tx_enable:0,true;
< VFO:0,0,8089500000;
?
the HF-Rig is now on 61mhz ??? and also my QO-100 rig
?
I can only get the correct RX/TX frequensy if I disable/enable the Rig?
?
using qlog 0.40
?
73" OZ1CT Ben?
?
?
 

This is New....after updated to 0.40

Ben

Send from my mobile office.

tirs. 26. nov. 2024, 12.51 skrev ok1mlg via <ok1mlg=[email protected]>:

Is this a new behavior, or have you seen it in previous versions?

ne 24. 11. 2024 v?14:15 odes¨ªlatel Bent Andersen via <eskolin=[email protected]> napsal:
If I use my HF-Rig and it run TCI-protocol, and if I am on 18mhz and change to my QO-100 rig, in the maneger, then Qlog send the TCI command
(The QO-100 rig use Hamlib via serial.)
?
?
> vfo:0,0,61440000;
> if:0,0,0;
> dds:0,8089500000;
> tune_drive:0,50;
> drive:0,50;
> tx_enable:0,true;
< VFO:0,0,8089500000;
?
the HF-Rig is now on 61mhz ??? and also my QO-100 rig
?
I can only get the correct RX/TX frequensy if I disable/enable the Rig?
?
using qlog 0.40
?
73" OZ1CT Ben?
?
?

1 - 3 of 3