¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io
  1. Nanovna-Users
  2. Topics

Problems

 

Try tapping the screen anywhere. I have no idea if this will work, but it
may be required for proper boot.

Dave - W?LEV

On Fri, Jan 22, 2021 at 10:28 PM Jim Tanis <jimnx0r@...> wrote:

I just received my nanovna-h. Screen booted fine, and I was starting to
learn how to use it. But for some reason I now when I turn it on, I only
get the screen attached. Is there anything I can do to make it work?





--
*Dave - W?LEV*
*Just Let Darwin Work*
 

Does not help.

On Fri, Jan 22, 2021, 4:55 PM David Eckhardt <davearea51a@...> wrote:

Try tapping the screen anywhere. I have no idea if this will work, but it
may be required for proper boot.

Dave - W?LEV

On Fri, Jan 22, 2021 at 10:28 PM Jim Tanis <jimnx0r@...> wrote:

I just received my nanovna-h. Screen booted fine, and I was starting to
learn how to use it. But for some reason I now when I turn it on, I only
get the screen attached. Is there anything I can do to make it work?





--
*Dave - W?LEV*
*Just Let Darwin Work*
 

Found the problem. The plastic screen protector was wadded up under the case cover. I removed the cover, cleaned off the protector , and reassembled. Works fine!
 

Hi Jim,
Based on the firmware, you received a previously assembled device. During manufacture, it was placed in either a burr or low-spacing housing, so this was a defect. If you place a plastic washer on the screw blocks, which raises the lid by approx. With 0.5mm, you won't have such a problem later. It is advisable to upgrade the firmware, the current latest is v1.0.45 made by DiSlord. You can also find it on my website or in the group wiki and Files folder. If you don¡¯t know how to do it, you¡¯ll also get an answer from the link above.
Successful use.

73, Gyula HA3HZ
--
*** If you are not part of the solution, then you are the problem. ( ) ***

1 - 4 of 4