This is a link to a previous discussion in this group about NanoVNA AppThanks The url does not point to a use of the nanoVNA-App software I have "COM9" which is displayed and Connected/Disconnected which switches. If I click "Calibration", [Click to open Calibration Window] I get the message "You need to be connected too your VNA" and then Connected/Disconnected no longer switches (stays on Disconnected). It may come from the fact that my nanaoVNA-F is not compatible with nanaoVNA-App while it is with nanaovna-saver. Software without manuals is not my age (73 years old). It's okay, nanovna-saver works fine. I am quite satisfied: in HF I compare the results produced by EZNEC on the basis of a description of a real antenna with the measurements made with my nanaoVNA-F + nanaovana-saver and it is "in the nails". 73 -- F1AMM (Fran?ois) -----Message d'origine----- |
NanoVNA-F is not compatible with NanoVNA App because the -F does not use a binaryThank you Roger Here's why it seemed to connect at low level and then it didn't work anymore. So that solves my notice problem :( -- F1AMM (Fran?ois) -----Message d'origine----- |
Roger Need