开云体育

After calibrating after upgrading to new firmware NanoVNA-H.v1.2.40.dfu from dsilord, the nano vna is showing what seems to be crazy flickering SWR values even after recalibrating and trying to find any setup that needs to be repeated.

Is this a known thing? Is it indicative that my device, labelled Nano-VNA-H and running a slightly earlier DSILord 1.2.x (1.2.30 I think) should go back to 1.2.30?

Warren VA7 WPX

If your nanovna-H is an MS version (rather than older SI version - see label on back for hardware revision number) - then you need to go into 'expert settings' and change the 'mode' to 'MS5351', then do 'save config'.
See if that is the problem.
Stan KC7XE

Yep...Just went through this myself. Mine was an MS version and dislord 1.2.40 defaults to SI.

Bryan, n0luf