开云体育

I read that Rigexpert Antscope 2 was now supporting 'most' NanoVNA models - I tried to connect my SAA-2N with 10/13/20 firmware to latest ver of Antscope 2 - It would not recognize the Nano. One post on another site said there was a 'connect to Nano' button under settings tab. Not on my version 1.1.4. Any suggestions appreciated.

Joe

On Sat, Jan 16, 2021 at 12:29 PM, joe gay wrote:

...I read that Rigexpert Antscope 2 was now supporting 'most' NanoVNA models ....

===========================================================

Should read "Rigexpert Antscope 2 was now supporting 'most' NanoVNA V1 models (NanoVNA, NanoVNA-H, & NanoVNA-H4)" . The NanoVNA-V2 uses register based serial commands instead of the console commands used by the NanoVNA V1 devices, so software written for one is not backwards compatible with the other - without a re-write.

- Herb

It is stated below that the work is in progress to support "all" versions of nanovna but it is unclear what is meant by "all". You may join the group and ask there.

/g/RigExpert-Family/message/486

Thanks for the info!
73 Joe